Vulcan-Hart 2G6BDF, ML-136654, ML-136656, ML-136657, ML-136681, 4G4BDF Operation, Filtering Procedure

Page 21

GBD_GBDF SERIES GAS FRYERS

Operation

Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer.

Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying compound from the tank.

Never run water or boil out solution through filter and motor / pump. Doing so will void your fryer warranty.

FILTERING PROCEDURE

Oil Temperature should be 300-350° F. Use the provided crumb scoop to remove and suspend crumbs on the bottom of the tank before proceeding to Step 1.

1. Do not turn off the Fryer. The power must be on throughout the entire filtering process.

Do NOT heat the fryer during the filtering procedure. Permanent damage to your fry tank may occur and warranty may be voided.

2.Vulcan recommends adding an oil treatment media to the oil prior to filtering.

3.Make sure that the filter drawer is closed completely and that the suction tube and receptacle block are in the correct position. Fig. 5

Fig. 5

VULCAN-HART

F-32934 Rev. B (June 2008)

-21-

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Installation & Operational Manual Important for Your Safety Table of Contents Ordering Parts IntroductionUnpacking GeneralFryer Model No Device Serial No InstallationClearances Codes and StandardsLocation United StatesAssembly Flue ConnectionCanada GAS Connection Testing the GAS Supply Piping SystemGAS Pressures ALL Models Fryers with CastersElectrical Connection Cleaning OVER-TEMPERATURE ShutdownLeveling the Fryer OperationBasic Frying Instruction Filling Tank with ShorteningExtending Shortening Life Fry Basket GuidelinesFry Basket Capacity Turning on the Fryer Turning OFF the FryerStart Button Filtering the OIL Extended ShutdownBoil OUT Procedure Weekly or when oil is replacedDraining the Tank Cleaning GAS KleenScreen Plus Models Filtering Instructions for KleenScreen Plus Fryers Same Suction Tube Step Do not Wash Fabric EnvelopeOperation Filtering ProcedureQuick Start Guide for Solid State Knob Controls Filtering in 6 Easy Steps Filtering TIP Removing Excess Debris from the Screen FilterFlush and Discard Thermal Overload Protection Button Boil OUT ProcedureService in the US and Canada MaintenanceFlue Vent Inspection Australia
Top Page Image Contents