Vulcan-Hart ML-136650 ML-136653, ML-136654, ML-136656, ML-136657, ML-136681 Electrical Connection

Page 9

GBD_GBDF SERIES GAS FRYERS

ŠWhen installing a quick disconnect you must also install a means for limiting the movement of the fryer. This device will prevent the gas line or quick disconnect from being strained. The restraining device should be attached to the cutout on the back panel. See illustration for location.

ŠIn Australia, use only the caster supplied by the manufacturer for the fryer device. The fryer must be installed using a hose assembly restraining device to limit the movement of the appliance in accordance with AS1869.

ŠThe fryer must be installed with a connector (not supplied by Vulcan) complying with the above codes.

ŠThe fryer must be installed with restraining means to guard against transmission of strain to the connector. See illustration.

ŠThe fryer must be installed with the casters provided.

ŠIf the restraint is ever to be disconnected, first turn the gas supply off.

ELECTRICAL CONNECTION

ŠThe fryer comes with a NEMA 15-5P plug that requires 120 Volt service. Plug in the wire connection into an approved outlet.

VULCAN-HART

F-32934 Rev. B (June 2008)

-9-

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Installation & Operational Manual Important for Your Safety Table of Contents Ordering Parts IntroductionUnpacking GeneralFryer Model No Device Serial No InstallationClearances Codes and StandardsLocation United StatesAssembly Flue ConnectionCanada GAS Connection Testing the GAS Supply Piping SystemGAS Pressures ALL Models Fryers with CastersElectrical Connection Cleaning OVER-TEMPERATURE ShutdownLeveling the Fryer OperationBasic Frying Instruction Filling Tank with ShorteningExtending Shortening Life Fry Basket GuidelinesFry Basket Capacity Turning on the Fryer Turning OFF the FryerStart Button Filtering the OIL Extended ShutdownBoil OUT Procedure Weekly or when oil is replacedDraining the Tank Cleaning GAS KleenScreen Plus Models Filtering Instructions for KleenScreen Plus Fryers Same Suction Tube Step Do not Wash Fabric EnvelopeOperation Filtering ProcedureQuick Start Guide for Solid State Knob Controls Filtering in 6 Easy Steps Filtering TIP Removing Excess Debris from the Screen FilterFlush and Discard Thermal Overload Protection Button Boil OUT ProcedureService in the US and Canada MaintenanceFlue Vent Inspection Australia
Top Page Image Contents