Cleveland Range (T) MKDL-80-T (-CC), (T) MKDL-125-T (-CC) manual Operating Suggestions

Page 11

Operating Suggestions

Cleveland Range Mixer Kettles are simple and safe to operate. The following tips will allow you to maximize the use of your new mixer.

OFF ON General Operation

1. Turn MAIN POWER SWITCH to "ON".

1. To achieve optimum performance on tilting

kettles;

Before applying steam to a cold kettle, open

the DRAIN COCK to drain condensate from the

kettles jacket. Close drain cock when unit is

fully drained.

2. Allow unit to preheat before addition of product to

kettle. However when cooking egg and milk

products, the kettle should NOT be preheated, as

products of this nature adhere to hot cooking

surfaces. These types of foods should be placed

in the kettle before heating is begun.

3. An important part of kettle cleaning is to

prevent foods from drying on. For this reason,

cleaning should be completed immediately

after cooked foods are removed. Refer to the

"Care and Cleaning" instructions for detailed

kettle washing procedures.

4. If a mixer bridge is equipped with a

temperature probe for a controller or

OFF

MIX LIFT

OFF

UP DOWN

Lifting & Lowering Bridge

WARNING- Insure FAUCET SPOUT is out of way before raising or lowering bridge.

1.Turn MIX/LIFT SWITCH to "LIFT".

2.Turn MIXER SPEED CONTROL to "MIN" and back up to #5.

3.Turn and hold UP/DOWN SWITCH "UP" to raise or "DOWN" to lower.

thermometer, the probe must be submerged a

minimum of three inches in the product for

accurate readings.

Safety

1.

Close PRODUCT DISCHARGE VALVE before

 

filling the kettle.

2.

When raising or lowering MIXER BRIDGE,

 

insure FAUCET SPOUT is not in the way of

 

MAIN AGITATOR ARM or damage to spout

 

will result.

3.

As a safety precaution the MIXER SPEED

 

CONTROL must first be turned to zero before

OFF

MIX LIFT

Mixing

1.Turn MIX/LIFT SWITCH to "MIX".

2.Turn MIXER SPEED CONTROL to "MIN" and slowly adjust to desired speed.

3.Adjust SECONDARY SPEED CONTROL to desired speed.

unit will start to mix.

4. Always remember, like a cooking pot the

kettles become very hot when cooking. Avoid

contact with bare skin.

Tilting Kettle

1.Raise MIXER BRIDGE and swing to side.

2.For manual tilt: turn

HANDWHEEL.

3.For power tilt: turn switch "" to raise, or "" to tilt.

WARNING- Do not tilt kettle when mixer agitators are in kettle bowl.

Image 11
Contents Operators Manual For your safety Clearance Requirements GeneralInspection Shipping Damage InstructionsLeveling Moving UnitPiping Connections Electrical Service ConnectionsCompressed AIR Connection Steam Pipe Sizing Piping SchematicSteam Requirements for Kettles Quality Assurance Checklist Some units may not have the following items to test Operating Instructions Item no Description Function Operating Suggestions 2000 Mixer Kettle Operation Using CAL Mixer Kettle Operation Using MRC 7000 1 PEN Cleaning Instructions Care and CleaningProduct Valve Scraper BladesStainless Steel Equipment Care and Cleaning Warranty Service PartsItem no Hydraulic ComponentsKE50294 Mercury Switch FA95055-3 Cleveland Remote Control AssemblyDescription QTY Main Console Controls Item no Description Index Switch ConfigurationSpeed Control Electrical Component Assembly Bracket for Thermostat Solenoid Valve, 1 1/4 100 psi Plumbing Assembly 10 ConsolePlumbing Assembly 18 Console Manual Tilt 10 Console Power Tilt 10/12 Console Power Tilt 10/12 Console Water Meter Assembly 18 Console Water Meter Assembly Console Flush Piston Flush Piston AIR SYSTEM, 10 Console Lubricator Used Prior to Item on Description QTY Used After to For MKDL-40CC Flush Piston AIR Solenoid Valve Butterfly Valve Valves Main Component Reference ChartsMaintenance Steam Trap AIR Line Lubricator OIL Filling ProcedureAIR Filter Replacement Procedure Automatic Dump ValveHydraulic OIL Replacement Procedure RE-INSTALLING Speed Control CableLubrication Disassembly of Switch AssemblyOrdering Information Solenoid Valve MaintenanceCoil Replacement For Cook Chill Direct Steam Mixer Kettles MRC 7000 Enable Mode Procedure 1&2 PENWiring Diagram Twin Kettles Flow Path for Hydraulic System Spare Parts Spare Parts List