Cleveland Range (T) MKDL-125-T (-CC) manual Lubrication, Disassembly of Switch Assembly

Page 48

LUBRICATION

Lubricate the following parts every three months to insure smooth operation and reduce wear.

DISASSEMBLY OF SWITCH ASSEMBLY

Front	Back
Cover	Cover

Grease

Nipples

Side View of 18" Console

Adjusting

Screw

Worm

Screw and

Tilt

Gear

Cross

Bar

MIXER BRIDGE HOUSING

There are two grease nipples on the mixer bridge swivel housing which are accessed by removing the front and back covers on the 18" console.

TRUNNION

HOUSING, WORM SCREW AND TILT GEAR

These parts are accessed through the front cover on the 18"

Fig. 1
	Contactor
	cartridges
Fig. 2
Fig. 3
Fig. 4	Cartridge
	Cartridge
Locking	mounting
ring	block
ring
Rotary switch

1.Place slotted screwdriver between contactor cartridge and cartridge mounting block as shown in Fig.1.

2.Twist screwdriver to free cartridge.

3.Place screwdriver under tab in the back of the cartridge mounting block as shown in Fig. 3.

4.Twist screwdriver to remove block from the rotary switch.

3.Unscrew locking ring to remove rotary switch.

Trunnion and Tilt Mechanism Drawing

console.

Switch Assembly

Apply grease to gear teeth. Check for excessive play and adjust with adjusting screw located on top of cross bar.

Trunnion Housing

Grease Nipple

KETTLE

TRUNNIONS

Accessed via the top covers on the 10" and 18" consoles. Each has two grease nipples.

Kettle Trunnion Drawing

Image 48

Contents Operators Manual For your safety General InspectionShipping Damage Instructions Clearance RequirementsMoving Unit LevelingElectrical Service Connections Compressed AIR ConnectionPiping Connections Piping Schematic Steam Requirements for KettlesSteam Pipe Sizing Quality Assurance Checklist Some units may not have the following items to test Operating Instructions Item no Description Function Operating Suggestions 2000 Mixer Kettle Operation Using CAL Mixer Kettle Operation Using MRC 7000 1 PEN Care and Cleaning Cleaning InstructionsScraper Blades Product ValveStainless Steel Equipment Care and Cleaning Service Parts WarrantyHydraulic Components Item noKE50294 Mercury Switch FA95055-3 Remote Control Assembly ClevelandDescription QTY Main Console Controls Item no Description Switch Configuration IndexSpeed Control Electrical Component Assembly Bracket for Thermostat Plumbing Assembly 10 Console Solenoid Valve, 1 1/4 100 psiPlumbing Assembly 18 Console Manual Tilt 10 Console Power Tilt 10/12 Console Power Tilt 10/12 Console Water Meter Assembly 18 Console Water Meter Assembly Console Flush Piston Flush Piston AIR SYSTEM, 10 Console Lubricator Used Prior to Item on Description QTY Used After to For MKDL-40CC Flush Piston AIR Solenoid Valve Butterfly Valve Main Component Reference Charts ValvesMaintenance AIR Line Lubricator OIL Filling Procedure AIR Filter Replacement ProcedureAutomatic Dump Valve Steam TrapRE-INSTALLING Speed Control Cable Hydraulic OIL Replacement ProcedureDisassembly of Switch Assembly LubricationSolenoid Valve Maintenance Ordering InformationCoil Replacement MRC 7000 Enable Mode Procedure 1&2 PEN For Cook Chill Direct Steam Mixer KettlesWiring Diagram Twin Kettles Flow Path for Hydraulic System Spare Parts List Spare Parts