MRC 7000 ENABLE MODE PROCEDURE (1&2 PEN)
For Cook Chill Direct Steam Mixer Kettles
Reference page #36 in the MRC 7000 Installation, Wiring, Operation Manual, Form 2877, Edition 6, May 1994 update.
Press and hold both keys until "EnAb" appears (about 10 seconds).
When you release the keys "EtSt " will appear.
EnAb
Push to turn "on"
Push to turn "oFF"
To prevent tampering, your programmer comes from the factory with the programming modes turned "oFF ".
If adjustment is required then the modes must be turned "ON " before they are accessible. We recommend that when the adjustments have been completed you turn off the programming modes again.
To turn on the mode required perform the following steps:
Test
Mode
Calibration Mode
Program Mode
EtSt 
oFF 
Factory
Setting
ECAL 
oFF 
| Factory |
| Setting |
EPro | oFF |
| Factory |
AUTO
MAN
AUTO
MAN
MAN OUT1 OUT2 ALRM
SP
Pen1 key -
AUTO/MAN
SCROLL Key
UP Key
DOWN Key
Pen 2 key -
AUTO/MAN
Tune
Mode
Manual (Stby)Mode
Setpoint Select Mode (optional)
| Setting |
Etun | oFF |
| Factory |
| Setting |
ESbY 
oFF 
Factory
Setting
ESPS 
oFF 
Factory |
Setting |
CAL 9900 Controls Drawing
1. | Turn MAIN POWER SWITCH to "ON ". |
2. | Press the scroll key " " until "CtrL" is displayed. |
3. | Press and hold the " " and " " keys at the |
Setpoint Change
ESPC | on |
| Factory |
| Setting |
| same time. All the display lamps will light. | ||
4. | After 10 seconds the display lights will go out | ||
| and "EnAb" will be displayed. Release the | ||
| " " and " | " keys. "EtSt " will appear. | |
5. | Repeatedly press the " | " key until the | |
| desired mode is displayed. | ||
6. | Press the scroll key " | " once to display the | |
| mode’s setting ("ON " or "oFF "). | ||
7. | Press the " | " key to turn the desired mode | |
| "ON ". |
|
|
8. | To turn desired mode "oFF " follow steps | ||
| and then press " " key. | ||
Note: Pressing the up key while any of the modes are displayed will exit you from the "EnAb" program.
MRC 7000 Enable Mode Flow Chart