Discharge Valve
1.For air valve: turn AIR REGULATOR clockwise to open, or counterclockwise to close.
2.For butterfly valve: push handle in and pull upwards to open.
Adding Water
Manually
1.Locate FAUCET SPOUT over desired kettle.
2.Turn on HOT or COLD WATER VALVES.
BYPASS ACTIVE
OFF
HEAT AUTO COOL
Manual Heating/ Cooling
1.Turn ACTIVE/BYPASS SWITCH to "BYPASS".
2.Turn CONTROLLER SWITCH to "HEAT" or "COOL".
3.For heat: open STEAM VALVE completely to boil, or adjust to regulate temperature.
For cooling: open STEAM
VALVE completely.
DIGITAL WATER METER OPERATING INSTRUCTIONS
Note: The digital counter has been preset at the factory and should operate satisfactory. If installing a new counter (or the configuration settings to your existing digital counter become corrupted) you must configure the digital counter as shown below (Configuring a Digital Counter) prior to operation.
2000 |
| Upper |
| 3 | Locate delivery spout over | |||
| Display |
| ||||||
|
|
| desired kettle. |
| ||||
|
|
|
|
|
|
|
| |
1930 |
| Lower |
|
|
|
| ||
| Display | CONTINUE RESET |
| Turn START switch to "RESET". | ||||
|
|
| ||||||
|
|
|
| |||||
|
|
| 4Delivery will start at "0" and stop at | |||||
PST | OUT | PGM |
| Program |
| preset volume. |
| |
|
|
|
|
|
| |||
|
|
|
| Indicator |
|
|
|
|
| ENT | RST |
| INTERRUPT |
|
|
| |
|
|
|
| To stop delivery at any time, turn | ||||
|
|
|
|
|
|
| ||
Down | Next |
| Enter | Reset |
| 5 INTERRUPT switch to " | ". | |
Key | Key |
| Key | Key |
|
|
|
|
OFF ON | 1 Turn POWER switch "ON". | 2 | Set required volume by first pushing the |
| |||
| key until the digit you want to change is |
flashing in the lower display. Then use the 
key to change the value of the selected digit.
When all digits are set, press the ENT key.
CONTINUE RESET | To complete delivery after |
| |
| 6 interrupting, turn START switch |
| to "CONTINUE" |
OFF ON |
|
| Turn POWER switch to "OFF" |
| 7when meter is not in use. |