QUALITY ASSURANCE
CHECKLIST
Follow this list only after all other installation steps are completed. Some steps require the use of equipment. Follow operating instructions.
The following will be performed before the unit is connected to utilities:
1. | Visual | Examine unit for scratches, dents, or other defects. |
2. | Visual | Check flanged feet all have bolts holding them. |
3. | General | Check all accessible wiring, mechanical and plumbing connections by hand for |
|
| secure, tight and satisfactory assembly. Remove all paper. |
4. | Level | Check unit has been leveled and squared correctly. |
The following will be performed with the unit connected to utilities: 5. Raise Bridge
6. | Swing Bridge | Bridge when fully raised should swing without hitting any object, i.e. control |
|
| housing, kettle lip. Check that hydraulic hoses are not being pinched by stops |
|
| on swivel assembly. |
7. | Tilt Kettle | Kettle tilts smoothly both down and back up. If power tilt, check that micro |
|
| switches are adjusted properly (kettle is level in upright position and drains fully |
|
| when tilted) and are not being crushed by gear. |
8. | Lower Bridge | Raise bridge. Switch to mix. Turn speed control to zero to reset micro switch then |
|
| set speed control to number four. Check that unit does not begin to mix until |
|
| bridge has lowered part way into the kettle. Check that mixer bridge pin lowers |
|
| into pin hole correctly |
9. | Speed Control - | Main agitator arm not rotating when set at minimum but will start to move slowly on |
| Main | one. Speed control makes positive contact with micro switch. |
10. Speed Control - | Set main speed control to five. Adjust secondary control from | |
| Secondary | minimum to maximum. Look for considerable speed variance. |
11. Water Faucets | Turn on hot water faucet. Turn off and check for leaks in piping and drips from | |
|
| faucet spout. Repeat above with cold water faucet. |
12. Product Discharge
Valve