Cleveland Range (T) MKDL-60-T (-CC), (T) MKDL-125-T (-CC) manual Scraper Blades, Product Valve

Page 16

SCRAPER BLADES

1.Remove retaining ring and slide scraper blades off agitator arm.

2.Place parts in a pan of warm water to soak.

3.Clean in a sink, using a warm water and mild detergent solution.

4.Rinse with fresh water.

5.Allow to dry thoroughly on a flat, clean surface.

PRODUCT VALVE

Daily - clean product valve as follows:

KETTLE

KETTLE

OUTLET

CLAMP

0-RING

VALVE

TEE

0-RING

CLAMP

0-RING

CLOSED

POSTITION

OPEN

POSITION

AIR HOSE

AIR

CYLINDER

AIR HOSE

1.Open product valve.

2.Disconnect air hoses.

3.Remove air cylinder.

4.Remove valve tee.

5.Remove all O-rings.

6.Clean air cylinder, do not submerge in water. Wipe clean and sanitize.

7.Clean and sanitize tee and O-rings.

8.Grease and reinstall O-rings.

9.Reinstall tee to kettle outlet.

10.Reinstall air cylinder to bottom of tee.

11.Reconnect air hoses.

12.Close valve and check for alignment.

Image 16

Contents Operators Manual For your safety General InspectionShipping Damage Instructions Clearance RequirementsMoving Unit LevelingCompressed AIR Connection Electrical Service ConnectionsPiping Connections Steam Requirements for Kettles Piping SchematicSteam Pipe Sizing Quality Assurance Checklist Some units may not have the following items to test Operating Instructions Item no Description Function Operating Suggestions 2000 Mixer Kettle Operation Using CAL Mixer Kettle Operation Using MRC 7000 1 PEN Care and Cleaning Cleaning InstructionsScraper Blades Product ValveStainless Steel Equipment Care and Cleaning Service Parts WarrantyHydraulic Components Item noKE50294 Mercury Switch FA95055-3 Remote Control Assembly ClevelandDescription QTY Main Console Controls Item no Description Switch Configuration IndexSpeed Control Electrical Component Assembly Bracket for Thermostat Plumbing Assembly 10 Console Solenoid Valve, 1 1/4 100 psiPlumbing Assembly 18 Console Manual Tilt 10 Console Power Tilt 10/12 Console Power Tilt 10/12 Console Water Meter Assembly 18 Console Water Meter Assembly Console Flush Piston Flush Piston AIR SYSTEM, 10 Console Lubricator Used Prior to Item on Description QTY Used After to For MKDL-40CC Flush Piston AIR Solenoid Valve Butterfly Valve Main Component Reference Charts ValvesMaintenance AIR Line Lubricator OIL Filling Procedure AIR Filter Replacement ProcedureAutomatic Dump Valve Steam TrapRE-INSTALLING Speed Control Cable Hydraulic OIL Replacement ProcedureDisassembly of Switch Assembly LubricationSolenoid Valve Maintenance Ordering InformationCoil Replacement MRC 7000 Enable Mode Procedure 1&2 PEN For Cook Chill Direct Steam Mixer KettlesWiring Diagram Twin Kettles Flow Path for Hydraulic System Spare Parts List Spare Parts