Troubleshooting
PROBLEM |
| SOLUTION |
Items not properly dried/ | • | Be sure Heated Dry is selected. |
moisture is present on the | • | Water droplets may form on the inner door as part of the drying process. |
dishwasher interior after the | • | Use a rinse aid separate from the detergent like Jet Dry* or Cascade Rinse Aid* |
dry cycle |
| regularly, to improve drying. Turn the rinse aid selector toward the MAX setting. |
| • Check water temperature. Incoming water should be 120° F (49° C). | |
| • | Select Sanitize. |
| • Increase detergent amount to match water hardness (pg. 5). | |
| • Load properly. (pg. | |
| • | Plastic and items with |
|
| porous surface which tends to collect water droplets. Towel drying may be necessary. |
| • Glasses and cups with concave bottoms hold water and require towel drying. Locate | |
|
| these items on the more slanted side of the rack for improved results. |
|
|
|
Dishware is chipped | • | Load dishes according to instructions so they do not strike each other (pg. |
| • Washing fine antique china/crystal in the dishwasher is not recommended. | |
| • Do not load glasses over the tines. | |
| • | Do not overload. |
|
|
|
Sanitized light does not | • | Sanitize was not selected. |
illuminate at the end of the | • | Sanitization can only be achieved with the Auto Wash (select models), Heavy Wash, |
cycle (select models) |
| Normal Wash or Quick Wash cycles. |
| • Sanitization may not be achieved if there is an interruption of the cycle, power failure | |
|
| or if incoming water temperature is below 120° F (49° C). |
|
|
|
*Brand names are trademarks of the respective manufacturer.
13