WhisperKool XLT 1600, XLT 8000, XLT 3000, XLT 4200, XLT 6000 Owners Please Note, Table of Contents

Page 3

TABLE OF CONTENTS
Introduction	2
Receiving and Inspecting	3
Quick Start Guide	4
Preparing the Wine Cellar	5
Installation	10
Using the WhisperKOOL System	13
Liquid Measuring Thermostat System	14
PDT JR. Operating Instructions	15
PDT Operating Instructions	16
Normal Operation	17
Maintenance Schedule	17
Ducting Option	18
Troubleshooting Guide	19
Troubleshooting Checklist	24
Temperature Differential Testing	26
Technical Assistance	29
Accessories	29
Limited Warranty & Terms and Conditions	30

OWNERS PLEASE NOTE

ALWAYS PLACE UNIT IN UPRIGHT POSITION

Do not start or plug-in your new unit for 24 hours after delivery.

Units are sometimes accidentally tipped onto their sides during shipping

which may allow compressor oil to escape their reservoirs.

Premature starting—before the oil has had a chance to resettle—can cause

damage to the compressor and result in a lack of cooling.

A DEDICATED 20 AMP CIRCUIT IS HIGHLY RECOMMENDED FOR OPTIMUM OPERATION!

Image 3

Contents XLT Page Owners Please Note Table of ContentsWhat is the WhisperKOOL System? IntroductionHow does the WhisperKOOL System Work? Receiving and Inspecting the Unit Customer Warranty RegistrationContents Receiving & Inspecting the UnitQuick Start Guide Wall & Ceiling Framing Preparing the Wine CellarUnobstructed Airflow Mounting the UnitDoor Ventilation Ambient Temperature FactorTools Needed Mark the horizontal lines with a levelCut horizontal lines from stud to stud Frame the hole with two-by-four supports Cut vertical lines along the inside edge of the studsSizing Unit to Room InstallationElectrical Needs Electrical OutletAttach precut foam tape to the unit’s flange Testing UnitApplying Insulation Tape Liquid Measuring Thermostat SystemPlacement of Unit Installing ThermostatLocation of control switches Using the Whisperkool SystemPower Switch Condensate Evaporator SwitchTo Use the thermostat Liquid Measuring Thermostat SystemPDT JR Operating Instructions ButtonsOperation PDT PDT Operating InstructionsHumidity Control Maintenance ScheduleMaintenance Normal OperationUsing the Thermostat Controller Ducting85F Max Troubleshooting Guide AirflowTry this first Door Seal Air flows on both sides of the wallCool air drops and exits beneath door Unit Mounting ThermostatMount WhisperKOOL high in the room Drainline Power RequirementsCondensation Icing UpConsumer Care Program Repairing Units Removing RivetsGeneral Inspection Troubleshooting ChecklistUnit is Not Cooling Sufficiently or Not Cooling at All Specific Performance IssuesDo not Exceed 24HRS on Bypass Plug Temperature Differential TestingInlet AIR -- Condenser Back Side Temperature / Test timeEvaporator Front Side Condenser Back Side Inlet AIR -- Evaporator Front SideConclusions Technical Assistance Accessories for Cooling UnitsFive 5 Year Compressor Limited Warranty Installation Terms and ConditionsProduct Installation Requirements Product Warranty Limitations and ExclusionsMaintenance Requirements Questions or Additional Information WhisperKOOLModelXLTSerial NumberA WhisperKOOL

TABLE OF CONTENTS

OWNERS PLEASE NOTE