WhisperKool XLT 4200, XLT 8000, XLT 3000, XLT 1600, XLT 6000 owner manual

Page 2

We manufacture, test and certify 100% of our wine cooling units in the USA. By sourcing the best components and closely controlling our manufacturing processes, we can assure the highest-quality, lowest defect manufacturing rates in the industry.

Copyright © 2011. WhisperKOOL Wine Cellars. All rights reserved.

This manual, the product design, and the design concepts are copyrighted by WhisperKOOL, with all rights reserved. Your rights with regard to the hardware and manual are subject to the restrictions and limitations imposed by the copyright laws of the United States of America. Under copyright laws, this manual may not be copied, reproduced, translated, transmitted, or reduced to any printed or electronic medium or to any machine-readable form, for any purpose, in whole or in part, without the written consent of WhisperKOOL.

Every effort has been made to ensure that the information in this manual is accurate. WhisperKOOL is not responsible for printing or clerical errors.

WhisperKOOL reserves the right to make corrections or improvements to the information provided and to the related hardware at any time, without notice.

Vinothèque and WhisperKOOL are registered trademarks, and ECE is a trademark of WhisperKOOL. All rights reserved.

Mention of third-party products is for informational purposes only and constitutes neither an endorsement nor a recommenda- tion. WhisperKOOL assumes no liability with regard to the performance or use of these products.

Rev. 2-1-11

Image 2

Contents XLT Page Table of Contents Owners Please NoteHow does the WhisperKOOL System Work? What is the WhisperKOOL System?Introduction Receiving & Inspecting the Unit Customer Warranty RegistrationContents Receiving and Inspecting the UnitQuick Start Guide Preparing the Wine Cellar Wall & Ceiling FramingDoor Unobstructed AirflowMounting the Unit Ambient Temperature Factor VentilationCut horizontal lines from stud to stud Tools NeededMark the horizontal lines with a level Cut vertical lines along the inside edge of the studs Frame the hole with two-by-four supportsElectrical Outlet InstallationElectrical Needs Sizing Unit to RoomLiquid Measuring Thermostat System Testing UnitApplying Insulation Tape Attach precut foam tape to the unit’s flangeInstalling Thermostat Placement of UnitCondensate Evaporator Switch Using the Whisperkool SystemPower Switch Location of control switchesLiquid Measuring Thermostat System To Use the thermostatOperation PDT JR Operating InstructionsButtons PDT Operating Instructions PDTNormal Operation Maintenance ScheduleMaintenance Humidity Control85F Max Using the Thermostat ControllerDucting Try this first Troubleshooting GuideAirflow Cool air drops and exits beneath door Door SealAir flows on both sides of the wall Mount WhisperKOOL high in the room Unit MountingThermostat Icing Up Power RequirementsCondensation DrainlineRepairing Units Removing Rivets Consumer Care ProgramTroubleshooting Checklist General InspectionSpecific Performance Issues Unit is Not Cooling Sufficiently or Not Cooling at AllTemperature Differential Testing Do not Exceed 24HRS on Bypass PlugInlet AIR -- Evaporator Front Side Temperature / Test timeEvaporator Front Side Condenser Back Side Inlet AIR -- Condenser Back SideConclusions Accessories for Cooling Units Technical AssistanceInstallation Terms and Conditions Five 5 Year Compressor Limited WarrantyProduct Warranty Limitations and Exclusions Product Installation RequirementsMaintenance Requirements ModelXLTSerial NumberA Questions or Additional InformationWhisperKOOL WhisperKOOL