Tappan 318200409 Installation Instructions continued, Oven Light, Surface Light, some models

Page 7
Installation Instructions (continued)

Installation Instructions (continued)

To level the range:

UNLOCK

LOCK

LOCKING THE FRONT ROLLERS (some of the 30” models only)

1.Use a 1-1/4” open end key or an adjustable wrench to equally unscrew the four leveling legs two to three turns each.

2.Install an oven rack in the center of the oven.

3.Move the range to its final position, then put a spirit level on the rack to check for levelness. Take two readings, one with the level placed diagonally first in one direction, and then the other.

4.Use the 1-1/4” key or wrench to adjust the leveling legs. Turn each one until the range stands firm without wobbling.

5.Some models are supported by smooth glide rollers to facilitate moving.

If floor is flat and level, open the drawer and lower the front roller locking levers (some models) to prevent the range from moving.

If floor is not flat or level or if this model has rollers without locking levers, use the 4 leveling legs to level, support and prevent the range from moving.

Oven Light

Do not turn the oven light on during the self-cleaning cycle.

High temperature will reduce lamp life.

On some models an interior oven light will turn on automatically when the oven door is opened.

The oven light may be turned on when the door is closed by using the oven light switch located on or underneath the control panel.

On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.

THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.

To replace the light bulb:

CAUTION: BE SURE OVEN IS COOL.

1.Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3.Replace bulb with a 40 watt appliance bulb only.

4.For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.

Surface Light

(some models)

BE SURE ALL SURFACE ELEMENT CONTROL KNOBS ARE TURNED TO OFF “ To level the range: ”

AND ELEMENTS ARE COOL.

Use switch located on or underneath the control panel to turn the surface light ON/OFF.

Replace the surface light, if after repeated attempts to turn it on you are not successful.

SURFACE LIGHT REPLACEMENT (some models)

To remove and replace the fluorescent light:

1.Place your fingers under the tube at approx. 20.3 cm (8”) from each end.

2.To remove, turn the tube 90° then pull it down and out of its sockets.

3.To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in place. Turn on the surface light to make sure it will lit.

General 5 Information

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 318200409 Rev A ELECTRIC RANGESREAD AND SAVE THESE INSTRUCTIONS OWNERS GUIDEWARRANTY PERIOD WARRANTYELECTRIC RANGES FRIGIDAIRE PARTS AND SERVICEThe self-addressed PRODUCT G e n e r a l I n f o r m a t i o nSOME MODELS PLEASE DO THIS NOWDO NOT TOUCH SURFACE UNITS, AREAS NEAR THESE IMPORTANT INSTRUCTIONS FOR USINGIMPORTANT SAFETY INSTRUCTIONS Do not use the oven for storageSAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS continuedIMPORTANT INSTRUCTIONS FOR CLEANING YOUR RANGE IMPORTANT INSTRUCTIONS FOR USING YOUR OVENSAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE Installation InstructionsClearances and Dimensions IMPORTANT SAVE FOR THE LOCAL ELECTRICAL INSPECTOR’S USE. READ ANDOven Light Installation Instructions continuedDo not turn the oven light on during the self-cleaning cycle SURFACE LIGHT REPLACEMENT some modelsGOOD Setting Surface ControlsCircuit Protection Selecting Surface Cooking UtensilsConvection notes Convection Roasting some modelsAir Circulation in the Oven Convection CookingProblems Indicator LightBaking Problems and Solutions Chart Oven BakingPreheating Oven SettingsBroiler Clean-Up Tips BroilingEXPANDABLE RADIANT HEATING UNITS some models Ceramic Glass Cooktop some modelsTYPES OF HEATING UNITS USED REGULAR RADIANT HEATING UNITS some modelsUSE AND CARE OF GLASS SURFACE HOT SURFACE INDICATOR LIGHTSPECIAL CAUTION FOR ALUMINUM FOIL AND ALUMINUM COOKING UTENSILS THINGS TO REMEMBERDO USE ON CERAMIC GLASS COOKTOP CLEANING MATERIALS FOR CERAMIC GLASS COOKTOPSPECIAL CLEANING INSTRUCTIONS FOR MINERAL DEPOSITS AND DISCOLORATIONS USE AND CARE OF GLASS SURFACE continuedControl Panel Cleaning the ApplianceExterior Cleaning CLEANING AGENTSDAILY CLEANING For normal soil Cleaning the Appliance continuedPorcelain enamel cooktop cleaning instructions PORCELAIN ENAMEL COOKTOP CLEANINGAdhere to the following cleaning precautions Cleaning the Regular Oven Non self-clean ovenCleaning the Self-Clean Oven some models Preparing the Oven for Self-CleaningAUTOMATIC LOCK OFF OF THE SURFACE ELEMENTS What to Expect During CleaningSetting the Controls for a Clean Cycle To Remove and Replace the Oven DoorTo replace the external door panel Removable Outer Door Glass Panel some modelsTo Remove/Replace Storage Drawer To remove the external door glass panelGeneral 18 Information Staple or clip original invoice herePROBLEM AVOID SERVICE CHECK LISTBefore you call for service - read this INSTALLATIONSURFACE UNITS RANGE DOES NOT OPERATE continuedCERAMIC GLASS COOKTOP some models POOR BAKING RESULTS BROILING SELF-CLEANING OVEN some modelsAVOID TRANSPORTATION DAMAGE TO YOUR RANGE LISEZ ET CONSERVEZ CES INSTRUCTIONS CUISINIÈRES ÉLECTRIQUESGUIDE DE LUTILISATEUR GARANT GARANTIECUISINIÈRES ÉLECTRIQUES FRIGIDAIRE - PIÈCES ET SERVICEI n f o r m a t i o n s g é n é r a l e s N’utilisez pas la cuisinière pour entreposer des articles IMPORTANTES MESURES DE SÉCURITÉPOUR SURFACE DE CUISSON VITROCÉRAMIQUE SEULEMENT IMPORTANTES MESURES DE SÉCURITÉ suiteINSTRUCTIONS DE SÉCURITÉ IMPORTANTES POUR L’UTILISATION DE VOTRE SURFACE DE CUISSONBranchement Instructions d’installationEspaces prévus et dimensions Emplacementcertain modèles Instructions d’installation suiteLampe du four Lampe de surfaceMAUVAIS Réglage des commandes des foyers de surfaceCoupe-circuit de protection Choix des ustensiles de cuisine pour la cuisson sur les foyersoption disponible avec certains modèles Rôtissage par convection certains modèlesCirculation d’air dans le four Cuisson par convectionSolutions Tableau des Problèmes de cuisson au four et de leurs SolutionsVoyants lumineux Cuisson au fourPour la cuisson au gril Cuisson au grilRéglage du four PréchauffageFOYERS À ÉLÉMENT RADIANT RÉGULIER certains modèles FOYERS À ÉLÉMENT RADIANT DE DIMENSIONS VARIABLES certains modèlesSurface de cuisson vitrocéramique certains modèles TYPES DE FOYERS UTILISÉSD’ALUMINIUM ET DE RÉCIPIENTS EN ALUMINIUM Surface de cuisson vitrocéramique certains modèles suiteVOYANT AVERTISSEUR DE SURFACE CHAUDE PRÉCAUTIONS À PRENDRE AVEC L’EMPLOI DE PAPIERÀ NE PAS UTILISER SUR LA SURFACE DE CUISSON VITROCÉRAMIQUE certains modèles suiteCOMMENT NETTOYER LA SURFACE DE CUISSON VITROCÉRAMIQUE NETTOYEURS APPROUVÉS POUR LA SURFACE DE CUISSON VITROCÉRAMIQUESurface de cuisson à foyers spiralés certains modèles Tableau des commandesNettoyage de l’appareil Nettoyage extérieurPour la saleté tenace et les taches calcinées Nettoyage de l’appareil suiteNETTOYAGE DE LA SURFACE DE CUISSON EN ÉMAIL VITRIFIÉ NETTOYAGE QUOTIDIEN Pour la saleté normalePrenez les précautions de nettoyage qui suivent Nettoyage du four régulier four non autonettoyantNettoyage du four autonettoyant certains modèles Préparation du four avant l’autonettoyageTable de cuisson levable certains modèles Enlever et réinstaller la porteRéglage des commandes du four Ce qui peut survenir durant l’autonettoyagePour retirer la vitre extérieure de la porte Pour réinstaller la vitre extérieure de la portePorte avec vitre extérieure démontable certains modèles Retirer/replacer le tiroir de rangementInformations 18 générales Brocher ici votre factureLA CUISINIÈRE NE FONCTIONNE PAS Avant d’appeler un technicien de service lisez ce qui suitPROBLÈMECAUSE POSSIBLE / SOLUTION LISTE DES VÉRIFICATIONS PRÉVENTIVESSURFACE DE CUISSON LA CUISINIÈRE NE FONCTIONNE PAS suiteSURFACE DE CUISSON VITROCÉRAMIQUE certains modèles MAUVAIS RÉSULTATS DE CUISSON AU FOUR ÉVITEZ D’ENDOMMAGER L’APPAREIL DURANT SON TRANSPORT CAUSE POSSIBLE / SOLUTIONCUISSON AU GRIL AUTONETTOYAGE DU FOUR certains modèles
Top Page Image Contents