Danby DDW611WLED manual Wash Cycle Table, TURNING ON THE Appliance

Operating Instructions

STARTING A WASHING PROGRAM

WASH CYCLE TABLE	• ( * ) Means: Need to fill rinse in the Rinse-Aid Dispenser.
	• AHAM DW-1-2005 : This program is the test cycle. The rinse aid
	dispenser position 6 is recommended.

Program			Cycle selection	Description	Detergent	Running	Energy	Water	Rinse
			Information	of cycle	pre/main	time(min)	(Kwh)	(L)	Aid
			For the heaviest soiled loads,	Pre-wash
			such as pots,pans,casserole	Pre-wash (50°C)	3/15g	100	0.424	14.5	*
				Wash (55°C)
			dishes and dishes that have	Wash (50°C)
			been sitting with dried food	Rinse
	Heavy		on them for a while.	Rinse (65°C)
				Drying
			For normally soiled loads,	Pre-wash
				Pre-wash	3/15g	85	0.361	12	*
			such as pots, plates,glasses
				Wash (55°C)
			and lightly soiled pans.	Rinse
Normal
			standard daily cycle.	Rinse (65°C)
AHAM DW-1-2005				Drying
			For lightly soiled loads,such	Pre-wash
				Pre-wash (50°C)	3/15g	75	0.311	12	*
			as plates,glasses,bowls and	Wash (50°C)
			lightly soiled pans.	Rinse
				Rinse (60°C)
	Light
				Drying
				Pre-wash
			For lightly soiled loads, such as	Wash (50°C)					*
				Rinse	15g	70	0.274	9.7
			glasses, crystal and fine china.	Rinse (60°C)
				Drying
		Glass
				Pre-wash
			A shorter wash for lightly soiled	Pre-wash (50°C)	15g	45	0.233	12
			loads that do not need drying.	Wash (50°C)
				Rinse
				Rinse (55°C)
	Speed
			To rinse dishes that you plan to	Pre-wash	/	10	0.01	2.5
			wash later that day.

Soak

TURNING ON THE APPLIANCE

Starting a washcycle...

Draw out the basket (see the section entitled Loading the Dishwasher).

Pour in the detergent and insert the plug into the socket. The power sup- ply is 120V/60 Hz.

Make sure that the water supply is turned on to full pressure.

•Press the program button to select the program you need.

•Heavy->Normal->Light->Glass->Speed->Soak

•Then, press the start/restart button to start the dishwasher.

NOTE: When you press the Start/Reset button to pause a wash cycle, the display time will stop blinking and the program will pause. It remains in this stage of the cycle until you restart it again.

12