Whirlpool W10632883A installation instructions Style, Connect to Refrigerator

Page 10

Style 2

1.Unplug refrigerator or disconnect power.

2.Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water.

3.Locate a ¹⁄₂" (1.27 cm) to 1¹⁄₄" (3.18 cm) vertical cold water pipe near the refrigerator.

IMPORTANT:

■Make sure it is a cold water pipe.

■Horizontal pipe will work, but drill on the top side of the pipe, not the bottom. This will help keep water away from the drill and normal sediment from collecting in the valve.

4.Determine the length of copper tubing you need. Measure from the connection on the lower rear corner of refrigerator to the water pipe. Add 7 ft (2.1 m) to allow for cleaning. Use ¹⁄₄" (6.35 mm) O.D. (outside diameter) copper tubing. Be sure both ends of copper tubing are cut square.

5.Using a cordless drill, drill a ¹⁄₄" (6.35 mm) hole in the cold water pipe you have selected.

 

A

G

B

 

 

C

F E

D

A. Cold water pipe

E. Compression sleeve

B. Pipe clamp

F. Shutoff valve

C. Copper tubing

G. Packing nut

D. Compression nut

 

6.Fasten the shutoff valve to the cold water pipe with the pipe clamp. Be sure the outlet end is solidly in the ¹⁄₄" (6.35 mm) drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws slowly and evenly so the washer makes a watertight seal. Do not overtighten, or you may crush the copper tubing.

7.Slip the compression sleeve and compression nut on the copper tubing as shown. Insert the end of the tubing into the outlet end squarely as far as it will go. Screw the compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing in a container or sink, and turn ON the main water supply. Flush the tubing until water is clear. Turn OFF the shutoff valve on the water pipe. Coil the copper tubing.

Connect to Refrigerator

Style 1

1.Unplug refrigerator or disconnect power.

2.Remove and discard the short, black plastic part from the end of the water line inlet.

3.Thread the nut onto the end of the tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

NOTE: To avoid rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet.

A

B

C

D

 

A. Household water line

C. Ferrule (purchased)

 

B. Nut (purchased)

 

D. Refrigerator water tubing

4.Install the water supply tube clamp around the water supply line to reduce strain on the coupling.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

Style 2

1.Unplug refrigerator or disconnect power.

2.Remove and discard the plastic part that is attached to the inlet of the water valve.

3.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten.

4.Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help avoid damage to the tubing when the refrigerator is pushed back against the wall.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

 

A

 

B

 

C

 

D

 

E

A. Tube clamp

D. Compression nut

B. Tube clamp screw

E. Valve inlet

C. Copper tubing

 

7.On some models, the ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer.

Style 3

1.Unplug refrigerator or disconnect power.

2.Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator.

3.If the gray water tube supplied with the refrigerator is not long enough, a ¹⁄₄" x ¹⁄₄" (6.35 mm x 6.35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing.

NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

A

B

C

D

E F G

A. Refrigerator water tubing

 

E. Ferrule (purchased)

B. Nut (provided)

 

 

F. Nut (purchased)

C. Bulb

 

 

 

G. Household water line

D. Coupling (purchased)

 

 

4.Turn shutoff valve ON.

5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Refrigerator User Instructions Refrigerator Safety Unpack the Refrigerator Installation InstructionsBefore You Throw Away Your Old Refrigerator or Freezer Door Removal, Leveling and Alignment Base GrilleOn models with the ice storage bin on the door Remove the wiring clip using a ¹⁄₄ hex-head socket wrenchTools Needed On models with the ice storage bin inside the freezerReplace the Doors and Hinges Plug refrigerator into a grounded 3 prong outletTo Remove the Handles Handle Installation and RemovalTo Install the Handles Leveling and Door ClosingWater Supply Requirements Location RequirementsElectrical Requirements Recommended Grounding MethodStyle 1 Recommended Connect Water SupplyReverse Osmosis Water Supply Water PressureStyle Connect to RefrigeratorInstall Air Filter Installing the Status Indicator on some models Install Produce PreserverInstalling the Produce Preserver on some models Sensitivity to Ethylene ProductionCondition Temperature Adjustment Using the ControlsRefrigerator USE Crisper Humidity Control Convertible Drawer Temperature ControlWater and Ice Dispensers Water Dispenser To Dispense WaterTo Dispense Ice Ice DispenserRemoving and Replacing the Ice Storage Bin Ice Maker and Storage BinTurning the Ice Maker On/Off Dispenser LockRefrigerator Care CleaningTo Clean Your Refrigerator Water Filtration SystemLight Styles LightsTo Change a Light Bulb Freezer Compartment Lower Light Light Shield Removal Vacation and Moving CareFreezer Compartment Upper Light Light Shield Removal If You Choose to Turn Refrigerator Off Before You LeaveMoving Problem SolverPossible Causes and/or Recommended Solutions RefrigeratorFollowing noises are normal Possible Causes and/or Recommended SolutionsTemperature is too warm Interior moisture buildupDoors and Leveling Off-taste, odor ProperlyIce or water has an Or gray colorAccessories Performance Data Sheet Water Filtration SystemItems Excluded from Warranty Whirlpool Corporation Major Appliance WarrantyLimited Warranty This limited warranty does not coverInstrucciones Para EL Usuario DEL Refrigerador Seguridad DEL RefrigeradorDesempaque el refrigerador Instrucciones DE InstalaciónAntes de tirar su viejo refrigerador o congelador Remoción, nivelación y alineamiento de las puertas Cómo quitar la puerta Bisagra superior derechaQuite las puertas Herramientas NecesariasPara los modelos con depósito de hielo en la puerta Vuelva a colocar las puertas y las bisagras Nivelación y cierre de las puertas Cómo instalar y remover las manijasPara instalar las manijas Alineamiento de las puertasPara quitar las manijas Requisitos de ubicaciónRequisitos eléctricos Método de conexión a tierra recomendadoSuministro de agua de ósmosis inversa Requisitos del suministro de aguaConexión del suministro de agua Estilo 1 RecomendadoEstilo Conexión al refrigeradorCómo terminar la instalación Instalación del filtro de aireCómo instalar el filtro de aire en algunos modelos En los modelos sin muescas Instalación del preservador de Alimentos frescosEn los modelos con muescas Reemplazo del filtro de aireInstalación del indicador de estado en algunos modelos USO DE SU RefrigeradorUso de los controles Cómo ajustar los controlesEncendido/Apagado del enfriamiento Alarma de puerta entreabiertaCondición Regulación DE LA Temperatura Características adicionales Fast Ice Hielo rápidoDespachadores de agua y hielo Control de temperatura del Cajón convertibleControl de humedad del cajón Para verduras Para despachar aguaLa luz del despachador Para despachar hieloEl despachador de hielo El bloqueo del despachadorCómo quitar y volver a colocar el depósito de hielo Fábrica de hielo y depósitoPara encender y apagar la fábrica de hielo EstiloLimpieza Cuidado DE SU RefrigeradorSistema de filtración de agua Para limpiar su refrigeradorTipos de luces LucesPara cambiar los focos Cuidado durante las vacaciones Mudanzas Si Ud. decide apagar el refrigerador antes de irseMudanza Solución DE ProblemasCausas posibles y/o soluciones recomendadas Enfriamiento. Vea Uso de los controlesParece ruidoso ExcesivamenteEl refrigerador Los ruidos que se indican a continuación son normalesDespachador Las luces delEn algunos modelos Causas posibles y/o soluciones recomendadas Deshágase de los tres primeros lotes de hielo producidosHielo no funciona El despachador deDebidamente Accesorios Hoja DE Datos DEL Rendimiento Sistema de filtración de aguaEsta garantía limitada no cubre Garantía LimitadaExclusiones DE LA Garantía Exclusión DE Garantías ImplícitasWhirlpool Brand Home Appliances Instructions Dutilisation DU Réfrigérateur Sécurité DU RéfrigérateurDéballage du réfrigérateur Instructions DinstallationAvant de jeter votre vieux réfrigérateur ou congélateur Retrait, réglage de laplomb et alignement des portes Raccordement des câblesEnlever les portes Outillage NécessaireImportant Ne pas retirer l’une des vis a Réinstaller les portes et les charnières Nivellement et fermeture des portes Installation et démontage des poignéesInstallation des poignées Alignement des portesSpécifications électriques Exigences demplacementMéthode recommandée de mise à la terre Retrait des poignéesRaccordement de la canalisation deau Style 1 RecommandéSpécifications de l’alimentation en eau Alimentation en eau par osmose inverseRaccordement au réfrigérateur Installation du filtre à air sur certains modèles Installation du filtre à airAchever l’installation Ouvrir le robinet darrêtModèles avec encoches Installation du sachet de conservation Pour produits fraisRemplacement du filtre à air Modèles sans encochesAjustement des commandes Utilisation des commandesInstallation du témoin de statut sur certains modèles Utilisation DU RéfrigérateurCaractéristiques supplémentaires Fast Ice glace rapide Condition Ajustement DE LA TempératureRefroidissement On/Off marche/arrêt Heures à moins d’être annulé manuellementRéglage de lhumidité dans Le bac à légumes Commande de température dans Le tiroir convertibleDistributeurs d’eau et de glaçons Retirer le verre pour arrêter la distribution Distribution d’eauDistribution de glace Le distributeur de glaçonsMise en marche/arrêt de la machine à glaçons Pour retirer et réinstaller le bac à glaçonsMachine à glaçons et bac Dentreposage Le verrouillage du distributeurTémoin lumineux de létat du filtre à eau Remplacement du filtre à eauSystème de filtration de leau Réinitialisation de l’état du filtreNettoyage Entretien DU RéfrigérateurLampes Réinstallation du protège-ampoule Ampoule de rechangeVider le bac à glaçons Entretien avant les vacances ou Lors d’un déménagementDéménagement Fonctionne Résolution DE ProblèmesCauses possibles et/ou solutions recommandées Au congélateur de refroidir complètementLes bruits suivants sont normaux Le réfrigérateurSemble bruyant La températureAutre réglage. Voir Distributeurs deau et de glaçons Les lampes du distributeurSur certains modèles Distributeurs deau et de glaçonsGlaçons ET EAU Causes possibles et/ou solutions recommandées Le distributeur de glaçons ne fonctionne pas correctement Accessoires Feuille DE Données SUR LA Performance Système de filtration d’eauÉléments Exclus DE LA Garantie Garantie DE Gros Appareil Ménager Whirlpool CorporationGarantie Limitée La présente garantie limitée ne couvre pasPage W10632883A
Top Page Image Contents