Dishwasher Feedback Section

OPTION SELECTIONS

OPTIONS	CAN BE	WHAT IT DOES	ADDED TIME TO CYCLE		ADDED
	SELECTED WITH				WATER
			TYPICAL	MAX	GALLONS
					(LITERS)

Control Lock

Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle.

To turn on Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The Control Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked.

NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL, or by opening and closing the door before you are able to turn Control Lock off.

To turn off Control Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The light turns off.

NOTE: If your model requires you to press and hold 4 HOUR DELAY to lock the controls, the Control Lock LED will be on or off to indicate if Control Lock is active or not.

CONTROLS AND CYCLE STATUS

CONTROL PURPOSECOMMENTS

To start or resume a wash cycle

If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator flashes. The cycle will not resume until the door is closed and START/RESUME is pressed.

NOTE: If the Start/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds, the Start/Resume button LED will flash, an audible tone will be heard, and the cycle will not start.

To reset any cycle or options during selection.

To cancel a wash cycle after it's started.

Press and hold CANCEL/DRAIN to reset any control selections made.

See “Canceling A Cycle After Dishwasher Is Started” and “Changing A Cycle After Dishwasher Is Started” sections.

To turn the audible

Press and hold the Hi-Temp Scrub button for 3 seconds to turn the audible tones on or off.

tones on or off.

Only audible tones for confirming button presses can be turned on/off. Important audible

tones, such as indicating a cycle has been interrupted, cannot be deactivated.

CONTROLS AND CYCLE STATUS

CONTROL

PURPOSE

COMMENTS

The Cycle Status Indicator

Clean indicator glows when a cycle is finished.

Lights are used to follow the

If you select the Sani Rinse option, when the Sani Rinse cycle is finished,

progress of the dishwasher

the Sanitized indicator glows. If your dishwasher did not properly sanitize

cycle. Located on the front

your dishes, the light flashes at the end of the cycle. This can happen if the

of the dishwasher for front

cycle is interrupted, or the water could not be heated to the required

control models, and located

temperature.

on the top of the door for

The Clean and Sanitized lights go off when you open and close the door or

hidden control models.

press and hold CANCEL.

The Front Indicator Light or

The light will be blue if the dishwasher is washing or rinsing. The light will

Single Exterior Light (A)

be red when the dishwasher is drying. The light will be green to indicate

shows progress of your

that the cycle is complete. If the Front Indicator Light is blinking, see

dishwasher cycle by color

“Troubleshooting” section.

(for hidden control models

only).

The Cycle Status Display is used to follow the progress of the dishwasher cycle, and to show other information.

(Available on some models instead of Cycle Status Indicator Lights)

The indicators will inform you if you are able to add a dish to the cycle after it has started. It will also inform you if the dishwasher is washing, rinsing, drying, complete, and/or sanitized. They will show whether the control is locked and/or the delay option is selected. A series of bars will count down the duration of the cycle remaining from left to right. Each bar equals approximately 24 minutes of cycle length. The bars will also count down the delay feature from left to right, and the delay indicator will be activated.