•Apply flues support bracket to the wall touching the ceiling. Use the flues support bracket as a perforation diagram (the small slot in the support must coincide with the line previously drawn on the wall, if present), and mark two holes with a pencil. Make the holes and insert 2 dowels.
•Fix the flues support bracket to the wall with 2 screws. Fig. 10
•Hang the hood to the 2 upper screws.
•Introduce and screw the screws (and washers) up into the holes for the definitive fixing (COMPULSORY!!). Then, having checked the setting of the hood,
TIGHTEN ALL THE upper and lower SCREWS. Fig. 11 Note: the lower fixing points are visible removing the grease filters and they are at the sides of the hood
G | Ø 8 |
| |
| Ø 5x45 |
Fig. 10
Fig. 11
65