GSI Outdoors PNEG-970 Product Information, General information, Capacities and Specifications

Page 13

Introduction

1. Product Information

A.The Series II Sweep Hopper with Collector Ring includes the following components:

-hopper

-collector ring

-center brace support

-collector ring shield

NEVER enter a grain bin unless ALL power driven equipment has been shut- down. Disconnect and lockout power before entering the bin or servicing the equipment.

2.General information.

A.GSI reserves the right to improve its product whenever possible and practical to do so. We reserve the right to change, improve and modify products at any time without obligation to make changes, improvements and modifications on equipment sold previously.

B.This new hopper with collector ring has been engineered and manufactured to give years of dependable service. The care and maintenance of this equipment will affect the satisfaction and service obtained. By following the instructions and suggestions recommended, the owner should receive quality service for many years. If additional information or assistance should be required, please contact GSI.

C.It is important to check both the quantity of parts and their descriptions with the packing list enclosed within each package. All claims for freight damage or shortage must be made by the consignee within ten (10) days from the date of the occurrence of freight damage. The consignee should

accept the shipment after noting the damage or loss.

3.Capacities and Specifications

Electrical controls and wiring should be installed by a qualified electrician. The motor disconnect switches and conductor cables should comply with the Na- tional Electrical code and any local codes which apply. Reset and motor start- ing stations should be located so that the operator can see that all personnel are clear of the equipment.

A.Disconnect and lockout the power before entering the bin.

B.Disconnect and lockout the power before servicing the equipment.

There should ALWAYS be two (2) people in the work area.

A main power disconnect switch capable of being locked only in the OFF position should be used. It should be locked whenever work is being done on the hopper.

PNEG-970S2 Hopper w/ Collector Ring

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents PNEG-970 Series II Sweep Hopper With Collector RingCatalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Read and Understand Manual Safety InstructionsRotating Flight Operate Unload Equipment SafelyElectric Shock Hazard Install & Operate Electrical Equipment ProperlyPrepare for Emergencies Eye Protection Gloves Steel Toe Boots Respirator Hard HatDecal a DecalsRotating Flighting Operator Qualifications Product Information Capacities and SpecificationsGeneral information Slip Ring Information Specifications & ListingsAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Preform Pre-Start Checks Start-UpMaintain the Hopper MaintenanceCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217
Top Page Image Contents