GSI Outdoors PNEG-970 operation manual Slip Ring Information, Specifications & Listings

Page 14

Introduction

4. Slip Ring Information

Slip rings must be enclosed and protected from any contact by personnel. Means for the provision of this protection is the responsibility of the user. Various enclosure styles are available from Insul-8.

Specifications & Listings

A. R-Series Slip Ring products are built to UL specifications but are not generally certified or listed by any independent certifying or regulatory body.

B. The following specifications apply to all RSeries Slip Rings:

1.R-Series Slip Rings are intended for industrial use and require a permanent mounting means.

2.Maximum RPM for units w/o ball bearings is 125. Maximum for units with ball bearings is 500 RPM.

Temperature & Ampere/Voltage Ratings

A. R-Series Slip Rings withstand a maximum ambient temperature of 220° F.

B. The model number of the slip ring assembly indicates the ampacity and voltage rating of each type of ring and brush included on the assembly . (See page 34) Note: the actual ampacity may be affected by the type and size of the core lead wire (refer to NEC Table 310-16, 17,18, 19 and applicable notes).

Markings

1.Every slip ring is marked with a label on the outboard bearing (or enclosure) which includes the Insul-8/IER name and logo, the product catalog number and the individual product serial number.

2.The marking on slip rings includes the maximum amperage and voltage.

14

PNEG-970S2 Hopper w/ Collector Ring

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Series II Sweep Hopper With Collector Ring PNEG-970Catalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Safety Instructions Read and Understand ManualOperate Unload Equipment Safely Rotating FlightInstall & Operate Electrical Equipment Properly Electric Shock HazardEye Protection Gloves Steel Toe Boots Respirator Hard Hat Prepare for EmergenciesDecals Decal aRotating Flighting Operator Qualifications General information Capacities and SpecificationsProduct Information Specifications & Listings Slip Ring InformationAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Start-Up Preform Pre-Start ChecksMaintenance Maintain the HopperCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217
Top Page Image Contents