GSI Outdoors PNEG-970 operation manual Assemble the Crossbrace to the Hopper

Page 22

Assembly

3. ASSEMBLE THE CROSSBRACE TO THE HOPPER (cont.)

D.Making sure the lower tube assembly and drilled hole are aligned, bolt the crossbrace to the hopper using eight (8) 1/2"-13 x 1 3/4" hex bolts, flat washers, lock washers, and hex nuts.

crossbrace assembly

hopper

hex nut

lock washer

1/2"-13 x 1 3/4" hex bolt

E.Attach the 1" liquid-tight flex conduit coupling on the conduit assembly to the hopper.

F.Slide the lower tube weldment against the hopper and tack weld into position.

22	PNEG-970S2 Hopper w/ Collector Ring

Image 22

Contents Series II Sweep Hopper With Collector Ring PNEG-970Catalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Safety Instructions Read and Understand ManualOperate Unload Equipment Safely Rotating FlightInstall & Operate Electrical Equipment Properly Electric Shock HazardEye Protection Gloves Steel Toe Boots Respirator Hard Hat Prepare for EmergenciesDecals Decal aRotating Flighting Operator Qualifications Product Information Capacities and SpecificationsGeneral information Specifications & Listings Slip Ring InformationAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Start-Up Preform Pre-Start ChecksMaintenance Maintain the HopperCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217