GSI Outdoors PNEG-970 operation manual Maintenance, Maintain the Hopper

Page 28

Maintenance

1. Maintain the Hopper

ALWAYS shutdown and disconnect the power supply before adjusting, servicing or cleaning the equipment.

A.Use caution when repairing or replacing equipment parts.

B.Make sure ALL decals are legible and tightly attached to the hopper. If necessary, replace them FREE OF CHARGE by contacting GSI at:

GSI

P.O. Box 20

1004 E. Illinois St.

Assumption, IL 62510

(217)226-4421

C.Make sure ALL electrical wiring is not damaged, and that it meets proper wiring codes.

D.Make sure ALL components are in good working condition before use.

E.Grease the center pivot tube at least two (2) times each season.

28	PNEG-970S2 Hopper w/ Collector Ring

Image 28

Contents Series II Sweep Hopper With Collector Ring PNEG-970Catalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Safety Instructions Read and Understand ManualOperate Unload Equipment Safely Rotating FlightInstall & Operate Electrical Equipment Properly Electric Shock HazardEye Protection Gloves Steel Toe Boots Respirator Hard Hat Prepare for EmergenciesDecals Decal aRotating Flighting Operator Qualifications Product Information Capacities and SpecificationsGeneral information Specifications & Listings Slip Ring InformationAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Start-Up Preform Pre-Start ChecksMaintenance Maintain the HopperCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217