GSI Outdoors PNEG-970 Electric Shock Hazard, Install & Operate Electrical Equipment Properly

Page 8

Safety

INSTALL & OPERATE ELECTRICAL EQUIPMENT PROPERLY

Electrical controls should be installed by a quali- fied electrician and must meet the standards set by the national electrical code and all local and state codes.

Disconnect and lock out all power sources before installing wires/cables or servicing equipment.

ELECTRICAL WARNINGS

Electric Shock Hazard

A. Install and ground the slip ring and the entire unit in accordance with the National Electric Code and local codes and/or ordinances.

B. DANGER: Hazard of electrical shock or burn. Always disconnect the power from the collector ring before attempting to perform any service function. Follow lock-out/tag-out procedures as outlined in OSHA section 1910.147 where appropriate.

C. Do not use this slip ring with electrical loads greater than the rated current and voltage. (See page 34)

D. Information regarding the current and voltage rating of each slip ring is recorded on a tag permanently fastened to the ring assembly.

E. 1 R-Series Slip Rings withstand a maximum ambient temperature of 220° F.

F.The model number of the slip ring assembly indicates the ampacity and voltage rating of each type of ring and brush included on the assembly . (See page 34) Note: the actual ampacity may be affected by the type and size of the core lead wire (refer to NEC Table 310-16, 17,18, 19 and applicable notes).

8

PNEG-9702 Hopper w/ Collector Ring

Image 8
Contents Series II Sweep Hopper With Collector Ring PNEG-970Catalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Safety Instructions Read and Understand ManualOperate Unload Equipment Safely Rotating FlightInstall & Operate Electrical Equipment Properly Electric Shock HazardEye Protection Gloves Steel Toe Boots Respirator Hard Hat Prepare for EmergenciesDecals Decal aRotating Flighting Operator Qualifications General information Capacities and SpecificationsProduct Information Specifications & Listings Slip Ring InformationAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Start-Up Preform Pre-Start ChecksMaintenance Maintain the HopperCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217