GSI Outdoors PNEG-970 operation manual Rotating Flighting

Page 11

Safety

Decals (cont.)

A.DANGER Sign No. DC-1395 was supplied with your bin unloading equipment. This safety sign should be applied to the side of the bin near the bin opening, so it will be viewed by people entering into the bin storage building. Do not cover any safety signs or any other signs that are already there.

B.If the safety sign location suggested is not in full view because of equipment modifications, other equipment in the area or any reason, then locate the safety sign in a more suitable location.

C.Be certain the surface is clean, dry and free of dirt and oil. Peel paper backing from decals and stick into place. The adhesive backing will bond on contact.

Please remember, safety signs provide important safety information for people working near bin unloading equipment that is in operation.

ROTATING FLIGHTING!￿

THIS BIN￿ IS EQUIPPED WITH GRAIN AUGERS￿

WHICH CAN KILL OR DISMEMBER.

KEEP CLEAR OF ALL AUGERS AND NEVER ENTER￿

THIS BIN UNLESS ALL POWER IS￿

DISCONNECTED AND LOCKED OUT.

FAILURE TO DO SO WILL RESULT IN￿

SERIOUS INJURY OR DEATH!

DC-1395

If the Safety Sign cannot be easily read for any reason or has been painted over, replace it immediately.

Additional Safety Signs may be obtained free of charge from your dealer, distributor or ordered from the factory.

Order SAFETY SIGN NO. DC-1395

PNEG-970S2 Hopper w/ Collector Ring

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents PNEG-970 Series II Sweep Hopper With Collector RingCatalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Read and Understand Manual Safety InstructionsRotating Flight Operate Unload Equipment SafelyElectric Shock Hazard Install & Operate Electrical Equipment ProperlyPrepare for Emergencies Eye Protection Gloves Steel Toe Boots Respirator Hard HatDecal a DecalsRotating Flighting Operator Qualifications General information Capacities and SpecificationsProduct Information Slip Ring Information Specifications & ListingsAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Preform Pre-Start Checks Start-UpMaintain the Hopper MaintenanceCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217
Top Page Image Contents