GSI Outdoors PNEG-970 operation manual Assemble the Crossbrace

Page 16

Assembly

1. ASSEMBLE THE CROSSBRACE (cont.)

C.Feed the nine (9) stranded wires from the collector ring through the pivot tube and bolt the collector ring to the crossbrace assembly using four (4) 1/4"-20 x 1" hex bolts, lock washers, and hex nuts.

nine (9) stranded wires

pivot tube

crossbrace assembly

1/4"-20 x 1" hex bolt

collector ring

lock washer

hex nut

Do not completely assemble the remaining hopper parts until wiring is complete!

16	PNEG-970S2 Hopper w/ Collector Ring

Image 16

Contents Series II Sweep Hopper With Collector Ring PNEG-970Catalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Safety Instructions Read and Understand ManualOperate Unload Equipment Safely Rotating FlightInstall & Operate Electrical Equipment Properly Electric Shock HazardEye Protection Gloves Steel Toe Boots Respirator Hard Hat Prepare for EmergenciesDecals Decal aRotating Flighting Operator Qualifications Product Information Capacities and SpecificationsGeneral information Specifications & Listings Slip Ring InformationAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Start-Up Preform Pre-Start ChecksMaintenance Maintain the HopperCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217