GSI Outdoors PNEG-970 operation manual Wire the Collector Ring

Page 19

Assembly

2. WIRE THE COLLECTOR RING

Electrical controls and wiring should be installed by a qualified electrician. The motor disconnect switches and conductor cables should comply with the National Electrical code and any local codes which apply. Reset and motor starting stations should be located so that the operator can see that all personnel are clear of the equipment.

Note:The liquid-tight flex conduit may need to be trimmed to length.

A.Attach the 1" liquid-tight flex conduit coupling to one end of the 1" x 16" liquid-tight flex conduit.

B.Attach the 1" x 45 degree liquid-tight flex conduit coupling to the other end of the 1" x 16" liquid tight flex conduit.

C.Remove the protective housing from the collector ring.

D.Feed the multi-conductor cord through the conduit assembly and the 1" conduit hub on the collector ring.

E.Attach the 1" x 45 degree liquid-tight flex conduit coupling to the 1" conduit hub on the collector ring. Be sure to turn the conduit assembly down .

1" x 45 degree flex conduit coupling

multi-conductor cord

collector ring hub

1" x 16" flex conduit

 

1" flex conduit coupling

PNEG-970S2 Hopper w/ Collector Ring

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents PNEG-970 Series II Sweep Hopper With Collector RingCatalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Read and Understand Manual Safety InstructionsRotating Flight Operate Unload Equipment SafelyElectric Shock Hazard Install & Operate Electrical Equipment ProperlyPrepare for Emergencies Eye Protection Gloves Steel Toe Boots Respirator Hard HatDecal a DecalsRotating Flighting Operator Qualifications Product Information Capacities and SpecificationsGeneral information Slip Ring Information Specifications & ListingsAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Preform Pre-Start Checks Start-UpMaintain the Hopper MaintenanceCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217
Top Page Image Contents