GSI Outdoors PNEG-970 operation manual Assemble the Crossbrace to the Hopper

Page 21

Assembly

3. ASSEMBLE THE CROSSBRACE TO THE HOPPER

A.Feed the multi-conductor cord through the collector ring shield, lower tube assembly, and drilled hole in hopper side.

B.Bolt the collector ring shield to the crossbrace assembly using sixteen (16) 1/4"-20 x 1" hex bolts, flat washers, lock washers, and hex nuts.

C.Slide the lower tube assembly into the shield assembly.

crossbrace assembly

1/4"-20 x 1" hex bolt

flat washer

collector ring shield

lock washer

hex nut

lower tube assembly

multi-conductor cord

hopper

PNEG-970S2 Hopper w/ Collector Ring

21

Image 21

Contents PNEG-970 Series II Sweep Hopper With Collector RingCatalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Read and Understand Manual Safety InstructionsRotating Flight Operate Unload Equipment SafelyElectric Shock Hazard Install & Operate Electrical Equipment ProperlyPrepare for Emergencies Eye Protection Gloves Steel Toe Boots Respirator Hard HatDecal a DecalsRotating Flighting Operator Qualifications Capacities and Specifications Product InformationGeneral information Slip Ring Information Specifications & ListingsAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Preform Pre-Start Checks Start-UpMaintain the Hopper MaintenanceCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217