GSI Outdoors PNEG-970 operation manual Assemble the Crossbrace to the Sweep

Page 24

Assembly

3. ASSEMBLE THE CROSSBRACE TO THE SWEEP (cont.)

C.Connect the pivot plate to the backshield using two (2) 1/2"-13 x 1 3/4" hex bolts, flat washers, lockwashers, and hex nuts.

D.Fasten the pivot rod to the backshield and pivot plate using two (2) 1/2"-13 x 2" hex bolts, lockwashers, and hex nuts.

E.Screw the 45 degree grease fitting into the crossbrace assembly.

1/2"-13 x 2" hex bolt

pivot rod

hex nut

pivot tube

lockwasher

flat washerpivot plate

1/2"-13 x 1 3/4" hex bolt

crossbrace assembly

45 degree grease fitting

24

PNEG-970S2 Hopper w/ Collector Ring

Image 24
Contents Series II Sweep Hopper With Collector Ring PNEG-970Catalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Safety Instructions Read and Understand ManualOperate Unload Equipment Safely Rotating FlightInstall & Operate Electrical Equipment Properly Electric Shock HazardEye Protection Gloves Steel Toe Boots Respirator Hard Hat Prepare for EmergenciesDecals Decal aRotating Flighting Operator Qualifications Capacities and Specifications Product InformationGeneral information Specifications & Listings Slip Ring InformationAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Start-Up Preform Pre-Start ChecksMaintenance Maintain the HopperCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217