GSI Outdoors PNEG-970 operation manual Assembly

Page 18

Assembly

1. ASSEMBLE THE CROSSBRACE (cont.)

E.Slide the lower tube assembly into the shield assembly. Bolt the crossbrace to the hopper using four (4) 1/2"-13 x 1 3/4" hex bolts, flat washers, lock washers, and hex nuts (One on each side.).

hex nut

lock washer

flat washer

1/2"-13 x 1 3/4" hex bolt

crossbrace assembly

hopper

lower tube assembly

F.Slide the lower tube assembly against the hopper and mark the center.

G.Unbolt the crossbrace from the hopper and remove the shield assembly from the crossbrace.

H.Drill a 7/8" hole at the marked location on the hopper.

18	PNEG-970S2 Hopper w/ Collector Ring

Image 18

Contents Series II Sweep Hopper With Collector Ring PNEG-970Catalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Safety Instructions Read and Understand ManualOperate Unload Equipment Safely Rotating FlightInstall & Operate Electrical Equipment Properly Electric Shock HazardEye Protection Gloves Steel Toe Boots Respirator Hard Hat Prepare for EmergenciesDecals Decal aRotating Flighting Operator Qualifications Capacities and Specifications Product InformationGeneral information Specifications & Listings Slip Ring InformationAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Start-Up Preform Pre-Start ChecksMaintenance Maintain the HopperCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217