GSI Outdoors PNEG-970 operation manual Assemble the Crossbrace to the Sweep

Page 23

Assembly

4. ASSEMBLE THE CROSSBRACE TO THE SWEEP

A.Feed the nine (9) stranded wires from the collector ring through the pivot tube and hole in the back of the sweep head section.

B.Align the hole in the backshield with the pivot tube and push the sweep onto the pivot tube.

stranded wires

PNEG-970S2 Hopper w/ Collector Ring

23

Image 23

Contents PNEG-970 Series II Sweep Hopper With Collector RingCatalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Read and Understand Manual Safety InstructionsRotating Flight Operate Unload Equipment SafelyElectric Shock Hazard Install & Operate Electrical Equipment ProperlyPrepare for Emergencies Eye Protection Gloves Steel Toe Boots Respirator Hard HatDecal a DecalsRotating Flighting Operator Qualifications General information Capacities and SpecificationsProduct Information Slip Ring Information Specifications & ListingsAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Preform Pre-Start Checks Start-UpMaintain the Hopper MaintenanceCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217