GSI Outdoors PNEG-970 operation manual Wire the Collector Ring

Page 20

Assembly

2. WIRE THE COLLECTOR RING (cont.)

F.Wire the multi-conductor cord to the collector ring using the fork terminals provided in the following manner.

1.Thermal Protection Leads

a.Wire the "P1" lead from the control panel to ring "1".

b.Wire the "P2" lead from the control panel to ring "2".

2.Drive Motor Leads

a.Wire the three (3) power leads to rings "3", "4", and "5".

b.Wire the ground lead to ring "9".

3.Auger Motor Leads

a.Wire the three (3) power leads to rings "6", "7", and "8".

b.Wire the ground lead to ring "9".

G.Replace the protective housing onto the collector ring.

20	PNEG-970S2 Hopper w/ Collector Ring

Image 20

Contents Series II Sweep Hopper With Collector Ring PNEG-970Catalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Safety Instructions Read and Understand ManualOperate Unload Equipment Safely Rotating FlightInstall & Operate Electrical Equipment Properly Electric Shock HazardEye Protection Gloves Steel Toe Boots Respirator Hard Hat Prepare for EmergenciesDecals Decal aRotating Flighting Operator Qualifications General information Capacities and SpecificationsProduct Information Specifications & Listings Slip Ring InformationAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Start-Up Preform Pre-Start ChecksMaintenance Maintain the HopperCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217