GSI Outdoors PNEG-970 operation manual Assembly

Page 15

Assembly

1. ASSEMBLE THE CROSSBRACE

A.Assemble the 1" x 9 3/8" conduit to the 1" chase nipple using one (1) 1" conduit coupling.

B.Feed the nine (9) stranded wires from the collector ring through the conduit assembly and fasten it to the collector ring.

nine (9) stranded wires 1" chase nipple

1" conduit coupling

1" x 9 3/8" conduit

collector ring

PNEG-970S2 Hopper w/ Collector Ring

15

Image 15
Contents PNEG-970 Series II Sweep Hopper With Collector RingCatalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Read and Understand Manual Safety InstructionsRotating Flight Operate Unload Equipment SafelyElectric Shock Hazard Install & Operate Electrical Equipment ProperlyPrepare for Emergencies Eye Protection Gloves Steel Toe Boots Respirator Hard HatDecal a DecalsRotating Flighting Operator Qualifications Capacities and Specifications Product InformationGeneral information Slip Ring Information Specifications & ListingsAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Preform Pre-Start Checks Start-UpMaintain the Hopper MaintenanceCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217