GSI Outdoors PNEG-970 operation manual Problem Possible Cause Solution

Page 31

			Troubleshooting


Problem	Possible Cause		Solution

1. Sweep will not run.	A. Power cords may be	A1.	Plug in the power cords.
	unplugged.
	B. Foot switch may not be	B1.	Make sure the foot switch is
	actuated.		depressed and the switch is
			operating properly.
	C. Overloads may be tripped.	C1.	Reset the overloads.
	D. The collector ring may not be	D1. Check the collector ring
	making good connections.		terminals for proper contact.
		D2. Make sure the springs have
			correct tension according to
			the owners manual.

	1. Intermittent Signal	A.	Brush wear.	A1.	Verify brush wear per section.
	or Loss of Signal	A.	Brush wear.	A1.	Verify brush wear per section.
	or Loss of Signal
		B.	Spring pressure.	B1.	Check spring pressure
					per section.

C.Dirty contact surface. C1. Check contact surfaces for cleanness (Ring Polishing Kit available.)

D.	Bad springs.	D1. Visually check for spring fit
		and function. Adjust or
		replace as necessary.
E.	Short in wire.	E1. Check core wiring for
		short circuit.

PNEG-970S2 Hopper w/ Collector Ring

31

Image 31

Contents PNEG-970 Series II Sweep Hopper With Collector RingCatalog No. Slip Ring Serial No Date of Purchase Table of Contents Safety Safety Guidelines Read and Understand Manual Safety InstructionsRotating Flight Operate Unload Equipment SafelyElectric Shock Hazard Install & Operate Electrical Equipment ProperlyPrepare for Emergencies Eye Protection Gloves Steel Toe Boots Respirator Hard HatDecal a DecalsRotating Flighting Operator Qualifications Product Information Capacities and SpecificationsGeneral information Slip Ring Information Specifications & ListingsAssembly Assemble the Crossbrace Assembly Assembly Wire the Collector Ring Wire the Collector Ring Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Hopper Assemble the Crossbrace to the Sweep Assemble the Crossbrace to the Sweep Wire the Collector Ring to the Sweep Wire the Collector Ring to the Sweep Preform Pre-Start Checks Start-UpMaintain the Hopper MaintenanceCollector Ring Maintenance Catalog No. Slip Ring Serial No Date of Purchase Problem Possible Cause Solution Parts 12 & 16 Hopper Components X R D Warranty Box 1004 E. IL. St Assumption IL 217