Hearth and Home Technologies VRT-GR-P-CE, VRTIKL-CE, VRT-GY-P-CE Alcove Applications, Gas stove

M

N

P

R

Q

See Notes 3 & 4

V

(See Note 2)

V

T

S Electrical S

Service

D*

V

V

V

= VENT TERMINAL X = AIR SUPPLY INLET

= AREA WHERE TERMINAL IS NOT PERMITTED

A

=

31 cm

clearances above grade, veranda,

K

=

1.8 M

clearance to a mechanical

(See Note 1)

porch, deck or balcony

(powered) air supply inlet

L**

=

2.1 M

clearance above paved

B

=

31 cm

clearances to window or door

(See Note 1)

sidewalk or a paved driveway

that may be opened, or to perma-

located on public property

nently closed window. (Glass)

M*** =

46 cm

clearance under veranda, porch,

D*

=

31 cm

vertical clearance to unventilated

deck, balcony or overhang

1.1 M

vinyl

soffit or to ventilated soffit located

above the terminal

S

=

15 cm

clearance from sides of elec-

76 cm

for vinyl clad soffits and below

(See Note 5)

trical service

T

=

31 cm

clearance above electrical

electrical service

F

=

23 cm

clearance to outside corner

(See Note 5)

service

G

=

15 cm

clearance to inside corner

Alcove Applications

N

=

15 cm

non-vinyl sidewalls

H

=

91 cm

not to be installed above a gas

31 cm

vinyl sidewalls

meter/regulator assembly within 90

P

=

2.4 M

cm horizontally from the center-line

of the regulator

QMIN

RMAX

I

=

1.8 M

clearance to gas service regulator

1 cap

.91 M

2 x Q ACTUAL

2 caps

1.8 M

1 x Q ACTUAL

vent outlet

3 caps

2.7 M

2/3 x Q ACTUAL

J

=

31 cm

clearance to non-mechanical

4 caps

3.7 M

1/2 x Q ACTUAL

air supply inlet to building or the

combustion air inlet to any other

QMIN = # termination caps x 3 RMAX = (2 / # termination caps) x QACTUAL

gas stove

**a flue shall not terminate directly above a sidewalk or paved driveway which is located between two single family dwellings and serves both dwellings.

***only permitted if veranda, porch, deck or balcony is fully open on a minimum of 2 sides beneath the floor, or meets Note 2.

NOTE 1: On private property where termination is less than 7 feet above a sidewalk, driveway, deck, porch, veranda or balcony, use of a listed cap shield is suggested. (See flue components page)

NOTE 2: Termination in an alcove space (spaces open only on one side and with an overhang) are permitted with the dimensions specified for vinyl or non-vinyl siding and soffits. 1. There must be 2.7M minimum between termination caps. 2. All mechanical air intakes within 3M of a termination cap must be a minimum of 2.7M below the termination cap. 3. All gravity air intakes within 2.7M of a termination cap must be a minimum of .31M foot below the termination cap.

Figure 4.4 Minimum Clearances for Termination

NOTE 3: Local codes or regulations may require different clearances.

NOTE 4: Termination caps may be hot. Consider their proximity to doors or other traffic areas.

NOTE 5: Location of the flue termination must not interfere with access to the electrical service.

Heat & Glo assumes no responsibility for the improper performance of the gas stove when the flueing system does not meet these requirements.

Heat & Glo • VRTIKL-CE • 7031-292 Rev E • 12/07 9