Hearth and Home Technologies VRT-GR-B-CE, VRTIKL-CE, VRT-GY-P-CE Cap and Barrel Fastener System

I. Front Door Glass Assembly Installation J. Inner Glass Door Assembly Replacement

Remove the front door assembly by pulling bottom of front away from gas stove and lifting it off of the hooks on top of the gas stove (see Figure 8.15).

Refer to Figure 8.16: Position the four flat 6 mm spacer washers on the front door so that the four mounting screws pass through them. Position the glass over the front door.

Install the four protective barrels into the glass and the four nylon washers on top of the glass.

From inside the door front, pass the screws through to the outside and thread on the caps until tight.

Figure 8.15

Cap and Barrel Fastener System

	Nylon washer on back
Screw	and front of glass

Finishing Cap

Protective barrel sleeve through hole in the glass

of side Back door front

Figure 8.16

Turn the gas stove OFF and let it cool down before replacing the inner glass door assembly.

With the front door assembly removed from the gas stove, remove the inner glass door assembly by disengaging the spring-loaded latches at the bottom of the gas stove and lifting off of the two spring-loaded latches at the top of the gas stove.

Replace with a new inner glass door assembly.

Figure 8.17 Complete Assembly

CAUTION

Handle glass assembly with care.

•Inspect the gasket to ensure it is undamaged.

•Inspect the glass for cracks, chips or scratches.

•Do NOT strike, slam or scratch glass.

•Do NOT operate gas stove with glass door removed, cracked, broken or scratched.

•Replace glass assembly as a complete assembly.

28 Heat & Glo • VRTIKL-CE • 7031-292 Rev E • 12/07