Hearth and Home Technologies VRT-GR-P-CE manual Operating Instructions, Before Lighting Appliance

Page 29

9 Operating Instructions

A. Before Lighting Appliance

Read this entire manual prior to using the gas stove. Failure to follow the instructions may result in property damage, bodily injury, or even death.

•Remove all shipping materials from inside and/or under- neath the firebox.

•Review proper placement of logs, mineral wool.

•Check the wiring.

•Check the baffle adjustment.

•Ensure that there are no gas leaks.

•Ensure that the glass is sealed and in the proper posi- tion.

•Ensure that the flow of combustion and ventilation air is not obstructed (front grilles and flue caps).

WARNING

Glass door must be in place when gas stove is operating.

Risk of:

•Combustion Fumes

•Fire

Do NOT operate gas stove with glass door removed.

•Open viewing glass for servicing only.

•Glass door MUST be in place and sealed before operating gas stove.

•Only use glass door certified for use with gas stove.

•Glass replacement should be done by qualified technician.

WARNING

HOT SURFACES!

Glass and other surfaces are hot during operation AND cool down.

Hot glass will cause burns.

• DO NOT touch glass until it is cooled

•NEVER allow children to touch glass

•Keep children away

•CAREFULLY SUPERVISE children in same room as fireplace.

•Alert children and adults to hazards of high temperatures.

High temperatures may ignite clothing or other flammable materials.

•Keep clothing, furniture, draperies and other flammable materials away.

This appliance has been supplied with an integral barrier to prevent direct contact with the fixed glass panel. DO NOT operate the appliance with the barrier removed.

Contact your dealer if the barrier is not present or help is needed to properly install one.

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this gas stove. For assistance or additional information consult a qualified installer, service agency or the gas supplier.

WARNING

Do NOT use this gas stove if any part has been under water. Immediately call a qualified service technician to inspect the gas stove and to replace any part of the control system and any gas control which has been under water.

Î

Heat & Glo • VRTIKL-CE • 7031-292 Rev E • 12/07

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Do Discardnot What to do if you smell gasDo not Discard this Manual Serial No Model Name Test Lab Report No Manufactured DateTable of Contents Appliance Certification 1Listing and Code ApprovalsNon-Combustible Materials Combustible MaterialsInspect Appliance & Components Design & Installation ConsiderationsGetting Started Selecting Appliance Location 3Appliance Location and ClearancesClearances to Combustibles 15.2 25.7 30.8 137.2 91.4 78.1 33.7 39.410.2 78.1 91.4 Optional Stone Surround InstalledFlue Termination Minimum Clearances 4Termination LocationsGas stove Alcove ApplicationsFlue Components Flue InformationUse of Elbows Measuring StandardsFor Natural, Propane and Butane Gases Flueing DiagramsNatural Gas One 90 0 Elbow System Natural Gas Two 90 0 Elbows System Min H1 Max H1 + H2 Max Natural Gas Two 900 Elbows System V1 Min Max Natural Gas Three 90 0 Elbows System Step Horizontal TerminationBefore YOU Begin Slim Line Wall ThimbleFIG. B Minimum Clearance Balance Flue Pipe Vertical TerminationSecure Flashing with NON-HARDENING Sealant Roofing Nails Twist-lock the flue cap and seal Vertical Flue RestrictorCheck for GAS Leaks Gas InformationGas Pressure Requirements Gas Connection Shock Risk Ignition System Wiring7Electrical Information Remove Shipping Materials Appliance SetupUnbolting Appliance from the Pallet Leveling and Bolting Down the ApplianceOn TOP of Appliance AccessoriesTop to Rear Flue Conversion On Back of Appliance Installing the BafflePlacing Mineral Wool Positioning the LogsCap and Barrel Fastener System Before Lighting Appliance Operating InstructionsDo not Connect 240 VAC to the Control Valve Lighting the ApplianceAfter Appliance is Lit Frequently Asked QuestionsInitial Break-in Procedure After servicing Maintaining and Servicing ApplianceInspect Maintenance Tasks Maintenance TasksElectronic Ignition System TroubleshootingSymptom Possible Causes Corrective Actions 47.9 104.5 103.5 40.3 18.1 76.2 73.3 86.7 Appliance Dimension DiagramReference Materials 75.3 62.0 76.8 42.8 86.7 112.6 Appliance Dimension with Stone Surround DiagramSL-09D SL-12/17D SL-24D SL-36D SL-48D Flue Components DiagramTermination Kits Flue Components ListComponents Log Set Assembly Service PartsP2B/B2P-VRT-CE Description Serial # Part NumberValve Assembly REM-DLX-CE Warranty Policy Heat & GLO Limited 10 Year WarrantyContact Information Your Records for Model
Top Page Image Contents