Electrolux EOG 900 manual Fitting the Appliance and Cabinet

Page 39

INSTALLATION Flexible Pipe Installation.

FITTING THE APPLIANCE AND CABINET

It is recommended that a 3/8" 1100mm long angle bayonet flexible hose (B.F.S.) and a ½" straight socket (B.F.S.) be used for the installation. However any approved hose of the correct length can be used. IMPORTANT: Flexible tubing used must comply with BS 669 current editions. L.P.G. flexible connections must be of a type suitable for L.P.G. and capable of operation up to 50mbar and carry a red stripe, band or label.

NOTE: Only liquid sealants can be used in threaded gas connections. Do not use P.T.F.E. tape.

1Make suitable arrangements for gas and electric supplies into the installation site. Preferably a junction box or a 3 pin earthed socket should be situated at the back of the cabinet below the oven.

2The electrical connection to the appliance is at the rear bottom right hand side; the junction box or socket should be positioned accordingly.

3Fit the cabinet as Fig.1, make sure that it is level.

4When unpacking the appliance keep it on it's polystyrene base until it is put into the cabinet to avoid damage.

NOTE: It is imperative that the appliance is left in the base to protect both the appliance and the floor. Do not allow young children to play with any part of the packaging.

5Remove the oven and grill doors (See section B on page 43). Remove the fascia panel (See section A on page 42).

6If the gas supply bayonet and wall fixing bracket are to be located behind the appliance it must be located in the shaded area as indicated in Fig.3.

7Connect flexible hose to the gas inlet supply block see Fig.3. The hose should be long enough to allow the appliance to be withdrawn from the cabinet.

8Position the appliance in front of the cabinet and

run the supply cable (See Section 2) through the cabinet and connect to the junction box or socket. Ensure that the supply is isolated at this stage. Connect flexible hose to the bayonet connector.

N.B. Two people will be required to carry out the lifting procedure.

Warning: Do not attempt to lift this appliance by the handles.

9Lift the appliance into the cabinet making sure the hose and cable are not trapped. Push the appliance as far back as it will go.

10Centralise and fix the appliance using the six wood screws provided, in the position indicated in Fig.2.

11 Carry out gas soundness check.

Fig.2

NOTE: Check gas supply pressure before fitting fascia

 

(See SECTION 3).

 

39

Image 39
Contents ModelEOG900 For your safety IntroductionG 9 0 Contents Minimum aperture width Installing the oven For your safetyCabinet Dimensions LocationCooling fan for the controls General informationPlease note ConnectingFor your safetyto the electricity supplyIgnition Oven lightTo light Lighting the oven and grillGrill OvenLighting the oven and grill G 9 0 To turn off any burnerGrill gives variable heat settings GrillHeat control Cooking positions PreheatingPutting food on the grid Shelf positions are counted from the top downwards Grill shelfGrill pan is supplied with a removable handle Grill pan and handlePlate warming Heat zones Oven For your safetyOven shelves Burner flames Baking trays and dishes For your safetyRoasting CondensationOven cooking chart Mins. per ½ kg 1 lb and 15 mins Cook as above but calculate weight including stuffingGas Mins. per ½ kg 1 lb and 25 mins90kg 2 lb loaves Slow cooking Food preparation-slow cookingJoints of meat and poultry General points for slow cooking Frozen foods Soups, casseroles and stewsVegetables Milk puddingsLiquid Milk and milk products, for example creamReheating To use the Countdown Electronic TimerElectronic timer To set the time of daySetting the controls for automatic use Electronic timer G 9 0Automatic control Turn off the oven control To cancel an automatic programmeHints and tips for automatic cooking Care and cleaning For your safety Do not overfill dishes or they will boil over GeneralTo remove the outer glass Cleaning between the outer and inner door glassLCheck What is wrong and why?Problem CheckG 9 0 Problem Replacing an oven light bulb G 9 0 Replacing an oven light bulb7 0 5 9 2 9 9 2 Service and spare partsCustomer Care Department Installation Instructions Technical Data Provision for Ventilation Important Safety RequirementsLocation of Appliance 560 min 570 maxFitting the Appliance and Cabinet Side View Front View Connection to Electricity Supply Pressure TestingRemoval of Fascia Panel RE-ASSEMBLE the ApplianceRemoval of Oven or Grill Doors Checking the GrillTo SET the Time of DAY Checking the Main Oven Automatic OperationGeneral Note Standard guarantee conditions Guarantee ConditionsEOG 900 Contents Check List Electrolux Household Appliances Limited Telephone 0870 5