4 Turn off the electricity supply and the thermostat; disconnect the pressure gauge and replace the test point plug . Turn on gas supply and check for gas soundness.
NOTE: The electrical supply must be connected in order to test the pressure.
FIG.7 | PRESSURE TEST | |
POINT | ||
|
INLET ELBOW
4. RE-ASSEMBLE THE APPLIANCE
1
2
A.REMOVAL OF FASCIA PANEL
1Remove the gas control knobs and timer control knobs.
2Remove the four screws (two each side) which are visible on the underside of the fascia. Fig.8.
3Tilt the bottom of the fascia panel out over. Withdraw the fascia panel by moving it down over to disengage it from the top fixing lugs.
4Replace in reverse order.
NOTE: To prevent the top fascia panel mounts becoming slack, it may be necessary to adjust the top fixing lugs.
FIG.8
42