Amana 8113P765-60 Care & Cleaning, Cleaning Procedures, Part Procedure, Display area

Care & Cleaning

Cleaning Procedures

CAUTION

•Be sure appliance is off and all parts are cool before handling or cleaning. This is to avoid damage and possible burns.

•To prevent staining or discoloration, clean appliance after each use.

•If a part is removed, be sure it is correctly replaced.

*Brand names are registered trademarks of the respective manufacturers.

**To order call 1-877-232-6771 USA or 1-800-688-8408 Canada.

PART	PROCEDURE
Cooktop –	Porcelain enamel is glass fused on metal and may crack or chip with misuse. It is acid resistant, not acid
Porcelain Enamel	proof. All spillovers, especially acidic or sugary spillovers, should be wiped up immediately with a dry cloth.
	•	When cool, wash with soapy water, rinse and dry.
	•	Never wipe off a warm or hot surface with a damp cloth. This may cause cracking or chipping.
	•	Never use oven cleaners, abrasive or caustic cleaning agents on exterior finish of range.
Clock and	•	To activate control lock for cleaning, see “Locking the Controls” page 9.
Control Pad	•	Wipe with a damp cloth and dry. Do not use abrasive cleaning agents as they may scratch the surface.
Area	•	Glass cleaners may be used if sprayed on a cloth first. DO NOT spray directly on control pad and
		display area.
Control Knobs	•	Remove knobs in the OFF position by pulling forward.
	•	Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
	•	Turn on each element to be sure the knobs have been correctly replaced.
Cooktop –	Never use oven cleaners, chlorine bleach, ammonia or glass cleaners with ammonia. Note: Call
Glass-Ceramic	an authorized servicer if the glass-ceramic top should crack, break or if metal or aluminum foil
	should melt on the cooktop.
	•	Allow the cooktop to cool before cleaning.
	•	General -- Clean cooktop after each use, or when needed, with a damp paper towel and Cooktop
		Cleaning Creme* (Part No. 20000001)**. Then, buff with a clean dry cloth.
	Note: Permanent stains will develop if soil is allowed to cook on by repeatedly using the cooktop when soiled.
	•	Heavy Soils or Metal Marks -- Dampen a “scratchless” or “never scratch” scrubber sponge. Apply
		Cooktop Cleaning Creme* (Part No. 20000001)** and scrub to remove as much soil as possible. Apply a
		thin layer of the creme over the soil, cover with a damp paper towel and let stand 30 to 45 minutes (2-3
		hours for very heavy soil). Keep moist by covering the paper towel with plastic wrap. Scrub again, then
		buff with a clean dry cloth.
	Note: Only use a CLEAN, DAMP “scratchless” pad that is safe for non-stick cookware. The pattern and glass
	will be damaged if the pad is not damp, if the pad is soiled, or if another type of pad is used.
	•	Burned-on or Crusty Soils -- Scrub with a “scratchless” or “never scratch” scouring pad and Cooktop
		Cleaning Creme*.
	Note: Hold a razor blade scraper at 30° angle and scrape any remaining soil. Then, clean as de-
	scribed above. Do not use the razor blade for daily cleaning as it may wear the pattern on the glass.
	•	Melted Sugar or Plastic -- Immediately turn element to Low and scrape sugar or
		plastic from hot surface to a cool area. Then turn element OFF and allow to cool. Clean
		residue with razor blade scraper and Cooktop Cleaning Creme*.

20