INSTALLATION INSTRUCTIONS
1.Remove all packing materials from the oven cavity, (do not remove the waveguide cover), and the feature sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if necessary.
2.Accessories provided
1) Turntable | 2) Roller stay |
3)Operation manual and Cook book
3.Place the roller stay in the coupling on the oven floor, then place the turntable on to the roller stay, ensuring it is located firmly. Refer to OVEN DIAGRAM below. NEVER operate the oven without the roller stay and turntable.
4.The oven should not be installed in any area where excessive heat and steam are generated, for example, next to a conventional oven unit. The oven should be installed so as not to block ventilation openings. When mounting on bench top : Allow at least 15cm on the top, 10cm on the both sides and 5cm at the rear of the oven for adequate air circulation.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an emergency.
5.Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
6.This appliance must be earthed.
7.Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with
8.For 330J(W), building the oven into the wall. A Sharp
OVEN DIAGRAM
| 6 |
| F E | A |
|
|
|
| B |
|
|
|
| 0 |
| 3 | 7 |
| 9 |
|
| C | ||
|
|
|
| |
|
|
|
| 1 |
|
|
|
| D |
4 | 5 | 8 | 2 4 |
|
1. Door open button |
|
| 9. Touch control panel | |
2. Oven lamp |
|
| 10. Liquid crystal display | |
3. Door hinges |
|
| 11. Ventilation openings | |
4. Door safety latches |
|
| 12. Power supply cord | |
5. See through door |
|
| 13. Turntable | |
6. Door seals and sealing surfaces | 14. Roller stay | |||
7. Coupling |
|
| 15. Rating label | |
8. Waveguide cover (Do not remove) | 16. Menu label |
4