ELAN Home Systems U102110-07 manual Griddle, Grill, Control Panel and Doors, Ovens

Page 19

Turn the head until the ‘D’ matches the one on the burner base. Turn the head over and place it on the burner base. To fit the small inner burner, find the larger electrode notch in the burner rim. Line this up with the white ignition electrode and place the inner burner on the large base ring.

A electrode notch

B ignition electrode

Now fit the two trim rings, making sure that they are sitting down properly.

Griddle

Always clean the griddle after use. Allow to cool completely before removing. Immerse the griddle plate in hot soapy water. Use a soft cloth or, for stubborn stains, a nylon washing up brush.

NEVER USE CAUSTIC OR ABRASIVE CLEANERS AS THESE WILL DAMAGE THE SURFACE.

Grill

The grill pan and grid should be washed in hot soapy water. After grilling meats or any foods that soil, leave to soak for a few minutes in the sink immediately after use. Stubborn particles may be removed from the grid by using a nylon brush.

Control Panel and Doors

Avoid using any abrasive cleaners including cream cleaners, e.g. Cif, on brushed Stainless Steel surfaces. For best results use a liquid detergent e.g. Domestos Multi Surface Cleaner.

The control panel and control knobs should only be cleaned with a soft cloth wrung out in clean hot soapy water. Wipe with a clean dampened cloth then polish with a dry cloth. The oven doors should only be cleaned with a soft cloth wrung out in clean hot soapy water.

Ovens

The ovens have removable panels that have been coated with a special enamel that partly cleans itself. This does not stop all marks on the lining, but helps to reduce the amount of manual cleaning needed.

The Cook & Clean panels work better above 200°C. If you do most of your cooking below this temperature, occasionally remove the panels and wipe with a lint free cloth and hot soapy water. The panels should then be dried and replaced and the oven heated at 200°C for about one hour. This will ensure the Cook & Clean panels are working effectively.

Don’t use steel wool (Brillo) or any other materials which will scratch the surface. Don’t use oven cleaning pads.

Removing the Oven Linings

Some of the lining panels can be removed for cleaning and for cleaning behind. Remove the shelves first.

The right hand fanned oven has a removable oven roof - slide the roof liner forward and remove.

The side panels of either oven can be removed. Each side of the oven is fixed with four fixing screws. You don’t have to remove the screws to remove the oven linings. Lift each side panel upwards and they will slide off the screws. Then pull them forwards.

Once the linings are removed, the oven enamel interior can be cleaned.

19

Image 19
Contents Dual Fuel Users Guide Gas and Electricity on Be safePeculiar smells Contents Hotplate Burners High/medium GriddleMedium/low Wok cradle Care and CleaningEssential information Grill Left Hand Oven Right Hand Oven OvensClock To turn off the key lock Auto is showing, you want to reset to manual cookingClock Special Features To activate the key lockBoth Ovens Cooking using the timerMulti-function oven functions Multi-function ovenConventional oven top and base heat HandyrackSteam Oven shelvesOven light To remove the drawer pull it fully forward StorageTo refit the draw Multi-function Oven cooking guide Cooking chart Fan assisted oven functionEnsure meat and poultry is fully cooked before serving Fish Oven Cooking chart Conventional and full Fan oven functionsWok burners Cleaning your cookerHotplate burners Central hotplateOvens GriddleGrill Control Panel and DoorsHotplate Part Finish Recommended Cleaning Method Cleaning TableMoving your cooker Troubleshooting Oven light is not working Oven temperature getting hotter as the cooker gets olderTurn off the power supply Grill not cooking properlyIf you smell gas General Safety Instructions0800 111 This appliance is heavy, take care when moving it Location of Cooker InstallationDear Installer Provision of VentilationElectric drill Masonry drill bit ConversionYou will also need the following tools Checking the partsUnpacking the Cooker Positioning the CookerMoving the Cooker Fit the Handles LevellingHandles should be above the fixings Gas Connection Pressure testingFitting the splash back Fitting a stability bracketFitting the plinth Electrical ConnectionHotplate Oven checkStick on label Tap adjustmentConversion to LP gas JetsServicing Notes To Change a Hotpate burner jet To Remove a ThermostatTo Change Grill Controller To Change a Hotplate TapTo Change Oven Door Seal To Adjust Oven Door Catch KeepTo Change Oven Door Outer Panel To Change Oven Door CatchTo Remove an Oven fan Element To Remove Oven Inner BackTo Remove the LH Oven Bottom and Top Elements To Replace an Oven FanCircuit Diagram Connections Technical DataDimensions This cooker is category II2H3+Ratings