ELAN Home Systems U102110-07 manual Storage, To remove the drawer pull it fully forward

Page 15

Storage

The bottom drawer is for storing oven trays and other cooking utensils.

It can get very warm, don’t store anything in it which may melt or catch fire.

The drawer can be removed completely for cleaning etc.

To remove the drawer pull it fully forward

Lift up the ends of the plastic clips (one each side) to release the catches holding the drawer to the side runners and at the same time pull the drawer forward and away from the side runners. For safety’s sake push the drawer runners back out of the way.

To refit the draw

Pull out the side runners. Rest the drawer back on the side runners and, keeping it level, push it right back. The clips should click into position holding the drawer to the side runners.

Image 15

Contents Dual Fuel Users Guide Be safe Gas and Electricity onPeculiar smells Contents Hotplate Burners Griddle High/mediumMedium/low Care and Cleaning Wok cradleEssential information Grill Left Hand Oven Right Hand Oven OvensClock To turn off the key lock Auto is showing, you want to reset to manual cookingClock Special Features To activate the key lockBoth Ovens Cooking using the timerMulti-function oven functions Multi-function ovenConventional oven top and base heat HandyrackOven shelves SteamOven light Storage To remove the drawer pull it fully forwardTo refit the draw Cooking chart Fan assisted oven function Multi-function Oven cooking guideEnsure meat and poultry is fully cooked before serving Fish Oven Cooking chart Conventional and full Fan oven functionsWok burners Cleaning your cookerHotplate burners Central hotplateOvens GriddleGrill Control Panel and DoorsHotplate Part Finish Recommended Cleaning Method Cleaning TableMoving your cooker Troubleshooting Oven light is not working Oven temperature getting hotter as the cooker gets olderTurn off the power supply Grill not cooking properlyGeneral Safety Instructions If you smell gas0800 111 This appliance is heavy, take care when moving it Location of Cooker InstallationDear Installer Provision of VentilationElectric drill Masonry drill bit ConversionYou will also need the following tools Checking the partsPositioning the Cooker Unpacking the CookerMoving the Cooker Levelling Fit the HandlesHandles should be above the fixings Gas Connection Pressure testingFitting the splash back Fitting a stability bracketFitting the plinth Electrical ConnectionHotplate Oven checkStick on label Tap adjustmentConversion to LP gas JetsServicing Notes To Change a Hotpate burner jet To Remove a ThermostatTo Change Grill Controller To Change a Hotplate TapTo Change Oven Door Seal To Adjust Oven Door Catch KeepTo Change Oven Door Outer Panel To Change Oven Door CatchTo Remove an Oven fan Element To Remove Oven Inner BackTo Remove the LH Oven Bottom and Top Elements To Replace an Oven FanCircuit Diagram Connections Technical DataDimensions This cooker is category II2H3+Ratings