ELAN Home Systems U102110-07 manual Wok cradle, Care and Cleaning, Essential information

Page 6

The Wok cradle

The Rangemaster Wok cradle is designed to fit a TyphoonTM Professional 14” Wok.

This is available from CookCraft (www.cookcraft.com) and also from other retailers.

Make sure the cradle is stable and that the Wok is sitting level in the ring.

If you use a different Wok make sure that it fits the cradle. Woks vary very widely in size and shape. It’s important that the Wok sits down on the pan support - but if the Wok is too small the cradle will not support it properly.

The cradle will get very hot in use - allow plenty of time for it to cool before you pick it up.

Care and Cleaning

Essential information

Never use paint solvents, washing soda, caustic cleaners, biological powders, bleach, chlorine based bleach cleaners, coarse abrasives or salt.

Recommended cleaning materials are hot soapy water, a moistened soap pad, cream cleaner or a nylon scourer.

The cradle should be used on the triple ring Wok burner only.

When you fit the cradle check that the Wok is properly located on the front and rear fingers and that it is supported properly on a pan support.

6

Image 6

Contents Dual Fuel Users Guide Be safe Gas and Electricity onPeculiar smells Contents Hotplate Burners Griddle High/mediumMedium/low Care and Cleaning Wok cradleEssential information Grill Ovens Left Hand Oven Right Hand OvenClock To activate the key lock Auto is showing, you want to reset to manual cookingClock Special Features To turn off the key lockCooking using the timer Both OvensMulti-function oven Multi-function oven functionsHandyrack Conventional oven top and base heatOven shelves SteamOven light Storage To remove the drawer pull it fully forwardTo refit the draw Cooking chart Fan assisted oven function Multi-function Oven cooking guideEnsure meat and poultry is fully cooked before serving Oven Cooking chart Conventional and full Fan oven functions FishCentral hotplate Cleaning your cookerHotplate burners Wok burnersControl Panel and Doors GriddleGrill OvensCleaning Table Hotplate Part Finish Recommended Cleaning MethodMoving your cooker Troubleshooting Grill not cooking properly Oven temperature getting hotter as the cooker gets olderTurn off the power supply Oven light is not workingGeneral Safety Instructions If you smell gas0800 111 This appliance is heavy, take care when moving it Provision of Ventilation InstallationDear Installer Location of CookerChecking the parts ConversionYou will also need the following tools Electric drill Masonry drill bitPositioning the Cooker Unpacking the CookerMoving the Cooker Levelling Fit the HandlesHandles should be above the fixings Fitting a stability bracket Pressure testingFitting the splash back Gas ConnectionOven check Electrical ConnectionHotplate Fitting the plinthJets Tap adjustmentConversion to LP gas Stick on labelServicing Notes To Change a Hotplate Tap To Remove a ThermostatTo Change Grill Controller To Change a Hotpate burner jetTo Change Oven Door Catch To Adjust Oven Door Catch KeepTo Change Oven Door Outer Panel To Change Oven Door SealTo Replace an Oven Fan To Remove Oven Inner BackTo Remove the LH Oven Bottom and Top Elements To Remove an Oven fan ElementCircuit Diagram This cooker is category II2H3+ Technical DataDimensions ConnectionsRatings