ELAN Home Systems U102110-07 Installation, Dear Installer, Provision of Ventilation, Thank you

Page 26

Installation

Dear Installer

Before you start your installation, please complete the details BELOW.

If your customer has a problem relating to your installation they will be able to contact you easily.

Thank you

Installer’s Name

Installer’s Company

Installer’s Telephone number

You must be aware of the following safety requirements & regulations

Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible.

This appliance shall be installed in accordance with the regulations in force and only in a well ventilated space. Read the instructions before installing or using this appliance.

In the UK the regulations and standards are as follows:-

In your own interest and that of safety, it is law that all gas appliances be installed by competent persons. CORGI registered installers undertake to work to safe and satisfactory standards. Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution. The cooker must be installed in accordance with

All relevant British Standards / Codes of Practice, in particular BS 5440 Part 2 2000, For Natural Gas - BS 6172 : 1990 and BS 6891 : 1998

For LP Gas - BS 5482-1:1994 (when the installation is in a permanent dwelling), BS 5482-2:1977, (when the installation is in a caravan or other non permanent dwelling), or BS 5482-3:1999 , (when the installation is in a boat).

The Gas Safety (Installation and Use) regulations 1998.

The relevant Building / IEE regulations.

Provision of Ventilation

This appliance is not connected to a combustion products evacuation device. Particular attention shall be given to the relevant requirements regarding ventilation.

The room containing the cooker should have an air supply in accordance with BS 5440 Part 2 : 2000. All rooms require an openable window or equivalent, while some rooms require a permanent vent in addition to the openable window. The cooker should not be installed in a bedsitting room with volume less than 20m3. If it is installed in a room of volume less than 5m3 an air vent of effective area 100cm2 is required; if it is installed in a room of volume between 5m3 and 10m3, an air vent of effective area 50cm2 is required; while if the volume exceeds 11m3, no air vent is required.

If there are other fuel burning appliances in the same room, BS 5440 Part 2 : 2000 should be consulted to determine the requisite air vent requirements.

Location of Cooker

The cooker may be installed in a kitchen/kitchen diner but NOT in a room containing a bath or shower.

NOTE:

An appliance for use on LPG shall not be installed in a room or internal space below ground level. e.g. in a basement.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Dual Fuel Users Guide Peculiar smells Be safeGas and Electricity on Contents Hotplate Burners Medium/low GriddleHigh/medium Essential information Care and CleaningWok cradle Grill Ovens Left Hand Oven Right Hand OvenClock To activate the key lock Auto is showing, you want to reset to manual cookingClock Special Features To turn off the key lockCooking using the timer Both OvensMulti-function oven Multi-function oven functionsHandyrack Conventional oven top and base heatOven light Oven shelvesSteam To refit the draw StorageTo remove the drawer pull it fully forward Ensure meat and poultry is fully cooked before serving Cooking chart Fan assisted oven functionMulti-function Oven cooking guide Oven Cooking chart Conventional and full Fan oven functions FishCentral hotplate Cleaning your cookerHotplate burners Wok burnersControl Panel and Doors GriddleGrill OvensCleaning Table Hotplate Part Finish Recommended Cleaning MethodMoving your cooker Troubleshooting Grill not cooking properly Oven temperature getting hotter as the cooker gets olderTurn off the power supply Oven light is not working0800 111 General Safety InstructionsIf you smell gas This appliance is heavy, take care when moving it Provision of Ventilation InstallationDear Installer Location of CookerChecking the parts ConversionYou will also need the following tools Electric drill Masonry drill bitMoving the Cooker Positioning the CookerUnpacking the Cooker Handles should be above the fixings LevellingFit the Handles Fitting a stability bracket Pressure testingFitting the splash back Gas ConnectionOven check Electrical ConnectionHotplate Fitting the plinthJets Tap adjustmentConversion to LP gas Stick on labelServicing Notes To Change a Hotplate Tap To Remove a ThermostatTo Change Grill Controller To Change a Hotpate burner jetTo Change Oven Door Catch To Adjust Oven Door Catch KeepTo Change Oven Door Outer Panel To Change Oven Door SealTo Replace an Oven Fan To Remove Oven Inner BackTo Remove the LH Oven Bottom and Top Elements To Remove an Oven fan ElementCircuit Diagram This cooker is category II2H3+ Technical DataDimensions ConnectionsRatings
Top Page Image Contents