Woods Equipment BW15LH manual Keep Away

Page 12

SAFETY & INSTRUCTIONAL DECALS

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

Replace Immediately If Damaged!

7 - PN 18864

WARNING￿￿￿￿￿￿ ￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿540￿￿￿￿￿￿￿￿￿￿RPM￿￿￿￿!￿￿￿￿￿"￿￿#￿￿￿￿￿$

18866-D

5- PN 18866 (540 RPM)

DANGER

ROTATING DRIVELINE

CONTACT CAN CAUSE DEATH

KEEP AWAY!

8 - PN 18865

WARNING

FALLING OFF CAN RESULT IN BEING RUN OVER.

„Tractor must be equipped with ROPS (or ROPS CAB) and seat belt. Keep foldable ROPS systems in “locked up” position at all times.

„Buckle Up! Keep seat belt securely fastened.

„Allow no riders.

RAISED EQUIPMENT CAN DROP AND CRUSH.

„Before working underneath, follow all instructions and safety rules in operator’s manual and securely block up all corners of equipment with jack stands.

„Securely blocking prevents equipment dropping from hydraulic leak- down, hydraulic system failures or mechanical component failures.

FALLING OFF OR FAILING TO BLOCK SECURELY CAN

RESULT IN SERIOUS INJURY OR DEATH.

18865--C

16 - PN 1004114

DANGER

If shaft connection is visible, shield is missing. Replace shield before

operating equipment.

1004114

10 - PN 19924

DO NOT OPERATE WITHOUT -

All driveline guards, tractor and equipment shields in place

Drivelines securely attached at both ends

Driveline guards that turn freely on

driveline18864-C

6 - PN 15503

DANGER

ROTATING BLADES AND

THROWN OBJECTS

Do not put hands or feet under or into mower when engine is running.

Before mowing, clear area of objects that may be thrown by blade.

Keep bystanders away.

Keep guards in place and in good condition.

BLADE CONTACT OR THROWN OBJECTS CAN CAUSE SERIOUS INJURY OR DEATH.

15503-C

19924-B

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿WARNING￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Check for leaks with cardboard; never use hand.

Before loosening fittings: lower load, release pressure, and

￿be sure oil is cool.

Consult physician immediately if skin penetration occurs.

12 Safety

MAN0810 (9/24/2009)

 

Image 12
Contents Batwing Introduction To the DealerTable of Contents LEA EL InstructivoSpecifications General InformationFree Mower Safety Video SafetyTraining Package for Rotary Mowers/Cutters-English Training Package for Rotary Mowers/Cutters-English/SpanishSafety Rules InstallationTraining PreparationTransportation OperationMaintenance Storage Safety & Instructional Decals Be CarefulKeep Away Safety Connecting Cutter to Tractor OperationOperation Hydraulic ConnectionCutting Height Adjustment Interference CheckCV Driveline Turning Limits Tractor OperationCutter Operation Mowing TipsShredding Transporting Lock-UpPRE-OPERATION Check List Owners ResponsibilityOwner Service Owner ServiceBlocking Method Lubrication Driveline LubricationGearbox Lubrication Blade Installation Figure Seasonal LubricationBlades Blade Removal FigureSlip Clutch Adjustment Figure Blade SharpeningCleaning Shielding RepairServicing Tires Safely Troubleshooting TroubleshootingDealer Service Dealer ServiceGearbox Maintenance Seal Replacement FigureVertical Shaft Seal Repair Spindle BOX Horizontal Shaft Seal RepairSpindle Gearbox Repair Remove Gearbox from Cutter Disassemble GearboxSpindle Gearbox Assembly Reinstall Gearbox Assemble GearboxDisassembly AssemblySplitter Gearbox Repair Figure Removal from Cutter Reinstallation on Cutter Check GearboxCrossbar Removal Crossbar RemovalCrossbar Installation Joint DisassemblyUniversal Joint Repair Joint Assembly Assembly Assembly InstructionsDealer SET-UP Instructions Install Height Adjustment Cylinder Install SMV EmblemInstall Wheel and Hub Install TongueInstall CV Drive Install WingInstall Wing Cylinder & Lock-up Bar Install Wing Wheel and Hub Figure Left Wing Lock-Up Bar InstalledInstall Wing Wheel Yoke Adjustment Link Install Wing DrivelineInstall Hose Kit Install Chain or Belt Shielding Chain Shielding Installation Center SectionChain Shielding Installation Right Wing Shown Belt Shielding Installation Right Wing Dealer Check Lists Dealer Check ListsPRE-DELIVERY Check List Delivery Check ListMAN0810 9/24/2009 Parts BW15LHMain Frame Assembly Front Section Part QTY Description Main Frame Assembly Rear Section Hydraulic cylinder 3 x 8 see Wing Assembly Part QTY Description Splitter Gearbox Assembly Shaft 1-3/4, 20 spline, center Wing & Center Gearbox Assembly Wing & Center Gearbox Assembly Center Deck Drive Assembly CV Drive Assembly Wing Drive Assembly Walterscheid Wing Drive Assembly Bodioli and Pavesi NSSBolt Wheel & Tire Assembly Rubber Shielding Center Section Standard Front & Rear Rubber Shielding Wing Standard Front & Rear Chain Shielding Center Section Optional Front & Rear Chain Shielding Wing Optional Front & Rear Hydraulic Cylinders Crossbar Puller Optional Hydraulic Cylinder Stroke Control KITWinch Kit Installation Winch KIT OptionalWinch Kit Operation Bolt Torque Chart SAE Series Torque ChartAppendix Metric SeriesBolt Size Chart AbbreviationsIndex IndexWarranty Warranty