Woods Equipment BW15LH manual Install Wheel and Hub, Install Tongue

Install Wheel and Hub

1.Insert wheel hub into outside of wheel yoke arm (17) and align holes.

2.Secure into position using cap screw (64) and flanged lock nut (68).

3.Attach wheel to hub using five lug nuts. Install the chamfered side of the lug nut toward the inside for steel rim for pnematic tires and rims. Tighten to 75 lbs-ft. Check that tire air pressure is a maximum of 40 psi.

NOTE: Install the flat side of the nut toward the inside for solid tires and aircraft tires (shown).

4.Install optional dual wheel and hub to inside of wheel yoke arm.

17.Center wheel yoke arm

64.1/2" NC x 3" HHCS GR5

68.1/2" NC Flange lock nut

Figure 24. Center Section Wheel and

Hub Installation

Install Tongue

1.Attach tongue (15) to center section using two cap screws (51) and lock nuts (55).

2.Attach attitude rod (6) to lug on tongue and secure with clevis pin (31), washer (52), and cotter pin (80).

3.Attach parking jack (16) to the side of the tongue.

4.Attach safety chain (8) to the bottom of center gusset and secure with cap screw (56), washer (59), and lock nut (60).

6.Attitude rod

8.Safety chain

15.Tongue

16.Parking jack

31. Clevis pin, 1" x 2.26"

51.1" NC x 4-1/2" HHCS GR5

52.Washer, flat 1"

55.1" NC Lock nut

56.3/4" NC x 2-1/4" HHCS GR5

59.Washer, flat 3/4" x 2" x 3/8"

60.3/4" NC Lock nut

80.Cotter pin, 1/4" x 1-1/2"

Figure 25. Tongue Installation

36 Assembly MAN0810 (9/24/2009)