Shindaiwa 81372, F222, T222 manual General Maintenance, Daily Maintenance, Hour Maintenance

Page 11

General Maintenance

IMPORTANT!

MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY

BE PERFORMED BY ANY REPAIR ESTABLISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHINDAIWA CORPORATION.

THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A WARRANTY CLAIM.

WARNING!

Before performing any maintenance, repair or cleaning work on the unit, make sure the engine and cutting attachment are completely stopped. Disconnect the spark plug wire before performing service or maintenance work.

WARNING

Non-standard parts may not operate properly with your unit and may cause damage and lead to personal injury.

NOTE:

Using non-standard replacement parts could invalidate your Shindaiwa warranty.

Muffler

This unit must never be operated with a faulty or missing spark arrester or muffler. Make sure the muffler is well secured and in good condition. A worn or damaged muffler is a fire hazard and may also cause hearing loss.

Spark Plug

Keep the spark plug and wire connections tight and clean.

Fasteners

Make sure nuts, bolts, and screws (except carburetor adjusting screws) are tight.

Daily Maintenance

Prior to each work day, perform the following:

■ Remove dirt or debris from the engine,

■ Carefully remove any accumulation of

check the cooling fins and air cleaner for

dirt or debris from the muffler or the

clogging and clean them as necessary.

fuel tank. Dirt build-up in these areas

 

could cause engine overheating, induce

 

premature wear, or create a fire hazard.

■Check for loose or missing screws or components. Make sure the cutting attachment is securely fastened.

■Check the entire unit for leaking fuel or grease.

10-Hour Maintenance

Unscrew

Remove and

Fastener

clean or replace

 

the element

Figure 21

 

Every 10 hours of operation (more

frequently in dusty or dirty conditions):

■Remove the air cleaner element. See Figure 21. Clean or replace as necessary. To clean element: wash it thoroughly in soap and water. Let it dry before reinstalling the element.

CAUTION!

Do not operate the unit if the air cleaner or element is damaged, or if the element is wet.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents T222 Trimmer F222 Trimmer Introduction ContentsStay Alert Minimize the Risk of Fire Safety InstructionsProperly Equipped Operator Work SafelyFeet Be Aware of the Working EnvironmentProduct Description SpecificationsPrior to Assembly Handle Assembly and AdjustmentsAdjust Throttle Lever Free Play Cutting Attachment Shield AssemblyInstall the Cutting Attachment Shield T222 Install the Cutting Attachment Shield F222Be used in your Shindaiwa engine Mixing FuelFilling the Fuel Tank Starting the EngineNever start the engine from the operating position When the Engine StartsIdle Speed Adjustment Stopping the EngineTrimming and Mowing Grass Checking Unit ConditionCutting Grass Engine Operating SpeedsHour Maintenance General MaintenanceDaily Maintenance Remove and replace the filter element 10/15-Hour MaintenanceGearcase Lubrication T222 Only Every 100 hours of operation, remove Long Term StorageEngine does not Start Troubleshooting GuideAdditional Problems Obtaining Warranty Service Manufacturers Warranty CoverageOWNER’S Warranty Responsibilities Maintenance and Repair Requirements¡ADVERTENCIA Podadora T222 Podadora F222Nota Introducción Declaraciones de Seguridad¡PRECAUCiÓN El Operario Debidamente Equipado Instrucciones de SeguridadPies Esté Alerta En Su Área De TrabajoEtiquetas de Seguridad Antes de Ensamblar Descripción del ProductoEspecificaciones Ajuste la holgura del acelerador Ensamblaje y Ajustes¡PRECAUCIÓN EnsamblajeEjemplos de cantidades de mezcla a proporción de Mezcla de CombustibleLlenando el Tanque de Combustible Arranque del MotorCuando arranca el motor… Arranque del Motor continuaciónParada del Motor Ajuste de Marcha Mínima del MotorCortar y recortar el césped Verifique la Condición de la UnidadCorte de Césped Máquinas Equipadas con Cabezal de Corte Velocidades de operación del motorMantenimiento Cada 10 Horas Mantenimiento GeneralMantenimiento Diario Retire y reemplace el elemento del filtro Mantenimiento Cada 10/15 HorasMantenimiento Cada 50 Horas Almacenamiento de Largo Plazo Cada 100 horas MantenimientoEl Motor No Arranca Guia DiagnosticoProblemas Adicionales Guia Diagnostico continuaciónLimitaciones Esta Garantía ES Administrada PORCobertura DE LA Garantía DEL Fabricante Piezas CubiertasAvertissement Débroussailleuses T222 F222Mise EN Garde Introduction Mises en gardeTable des matières Avertissement ! Les gaz d’échappement duDemeurer alerte Mesures de sécuritéÉquipement complet de l’utilisateur Sécurité au travailÉtiquettes de sécurité Tenir compte de l’environnement de travailAvant l’assemblage NomenclatureCaractéristiques techniques Poignée Assemblage et réglageRéglage du jeu du levier d’accélération Assemblage Installation du déflecteur T222Installation du déflecteur F222 Tête de coupe Installer la tête de coupeRéduire les risques d’incendie Mélange de carburantRemplissage du réservoir à carburant Démarrage du moteurLorsque le moteur démarre Démarrage du moteur suiteArrêt du moteur Réglage du ralenti du moteurFaire les bordures Contrôle de l’état de l’appareilVitesses de fonctionnement du moteur Tailler et tondre la pelouseEntretien aux 10 heures EntretienEntretien quotidien Lubrification du boîtier réducteur T222 seulement Retrait et remplacement de l’élément du filtreEntretien aux 10 à 15 heures Toutes les 10 à 15 heures de fonctionnementRemisage à long terme Entretien aux 100 heuresDes segments Guide de dépannageAutres Problèmes Guide de dépannage suiteLA Présente Garantie EST Gérée PAR Étendue DE LA Garantie DU FabricantPièces Prises EN Charge Exigences Relatives À L’ENTRETIEN ET LA RéparationRemarques FR18 FR19

81372, T222, F222 specifications

The Shindaiwa F222, 81372, and T222 are notable models within Shindaiwa's robust lineup of landscaping equipment, particularly designed for professional use. These tools are engineered to deliver high performance and reliability, making them ideal for both commercial landscapers and dedicated homeowners.

The Shindaiwa F222 is a powerful handheld blower known for its superior air speed and volume. With an exceptional engine output, it efficiently clears debris from various surfaces including lawns, gardens, and walkways. Its lightweight design ensures ease of use, reducing fatigue during extended operation. The F222 features an ergonomic handle that allows for a comfortable grip, and its well-balanced construction guarantees stability when in use. Additionally, the blower incorporates a low-emission engine technology, adhering to stringent environmental standards while still delivering ample power.

The Shindaiwa 81372 is recognized for its versatility as a hedge trimmer. This model boasts a dual-sided blade that provides a clean and precise cut, making it perfect for shaping and maintaining hedges and shrubs. The 81372 is equipped with a smooth-running, low-vibration motor that enhances user comfort, particularly during prolonged use. Furthermore, its lightweight and compact design make maneuvering easy, allowing operators to access tight spaces without hassle. With a focus on durability, Shindaiwa has designed the 81372’s blades to resist wear and maintain sharpness over time, ensuring longevity and optimal performance.

The T222, a robust trimmer, showcases Shindaiwa's commitment to power and efficiency. Engineered with a high-performance engine, the T222 delivers fast and efficient cutting, making it suitable for tackling thick grass and weeds. Its adjustable cutting head adds to its versatility, enabling users to reach various angles with ease. Additionally, the T222 is built with a comfortable grip and user-friendly interface, allowing for extended use without discomfort. Its lightweight construction makes it easy to handle, reducing the strain on the operator.

Across these models, Shindaiwa emphasizes innovative technologies, such as anti-vibration systems and fuel-efficient engines, ensuring that users can rely on their tools for productivity without compromising comfort. Overall, the Shindaiwa F222, 81372, and T222 represent a blend of power, efficiency, and user-friendly features, making them essential tools for landscaping professionals and enthusiasts alike.
Top Page Image Contents