Shindaiwa T222 Manufacturers Warranty Coverage, OWNER’S Warranty Responsibilities, Parts Covered

Page 16

The following statement only applies to United States and its territories

Shindaiwa Corporation

Federal Emission Design And Defect Limited Warranty

Utility And Lawn And Garden Engines

Shindaiwa Corporation warrants to the initial purchaser and each subsequent owner, that this utility equipment engine (herein engine) is designed, built and equipped to conform at the time of initial sale, to all applicable regulations of the U.S. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship that would cause this engine to fail to conform with EPA regulations during its warranty period. This emission warranty is applicable in all States, except the State of California.

For parts listed under PARTS COVERED, the dealer authorized by Shindaiwa Corporation will, at no cost to you, make the necessary diagnosis, repair, or replacement of any defective emission-related component to ensure that the engine complies with applicable U.S. EPA regulations.

MANUFACTURERS WARRANTY COVERAGE

When sold within the U.S., this engine’s emission control system is warranted for a period of two (2) years from the date this product is first delivered to the original retail purchaser.

OWNER’S WARRANTY RESPONSIBILITIES

As the engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. Shindaiwa Corporation recommends that you retain all receipts covering maintenance on your engine, but Shindaiwa Corporation cannot deny a warranty claim solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the engine owner, you should however be aware that Shindaiwa Corporation may deny your warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your engine to the nearest dealer authorized by Shindaiwa Corporation when a problem exists.

If your Shindaiwa Dealer is unable to answer questions regarding your warranty rights and responsibilities, you should then contact your Shindaiwa Distributor.

For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

PARTS COVERED

Listed below are the parts covered by the Federal Emission Design and Defect Warranty. Some parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement of that part. The warranted parts include:

1.Carburetor Internal Components

Valve Assembly-throttle, Jet, Metering Diaphragm . Ignition System Components

Ignition Coil

Flywheel Rotor

The emission control system for your particular Shindaiwa engine may also include certain related hoses and connectors.

(a)conditions resulting from tampering, misuse, improper adjustment (unless they were made by the dealer or service center authorized by Shindaiwa Corporation during a warranty repair), alteration, accident, failure to use the recommended fuel and oil, or not performing required maintenance services,

(b)the replacement parts used for required maintenance services,

(c)consequential parts used for required maintenance services,

(d)diagnosis and inspection fees that do not result in eligible warranty service being performed, and

(e)any non-authorized replacement part, or malfunction of authorized parts due to use of non-authorized parts.

MAINTENANCE AND REPAIR REQUIREMENTS

You are responsible for the proper use and maintenance of the engine. You should keep all receipts and maintenance records covering the performance of regular maintenance in the event questions arise. These receipts and maintenance records should be transferred to each subsequent owner of the engine. Shindaiwa Corporation reserves the right to deny warranty coverage if the owner has not properly maintained the engine. Shindaiwa Corporation will not deny warranty repairs, however, solely because of the lack of repair, maintenance or failure to keep maintenance records.

MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY REPAIR ESTABLISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHINDAIWA CORPORATION THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A WARRANTY CLAIM.

If other than the parts authorized by Shindaiwa Corporation are used for maintenance replacements or for the repair of components affecting emission control, you should assure yourself that such parts are warranted by their manufacturer to be equivalent to the parts authorized by Shindaiwa Corporation in their performance and durability.

OBTAINING WARRANTY SERVICE

All repairs qualifying under this limited warranty must be performed by a dealer authorized by Shindaiwa Corporation

If any emission-related part is found defective during the warranty period, it is your responsibility to present the product to an authorized Shindaiwa dealer. Bring your sales receipts showing the date of purchase for this engine. The dealer authorized by Shindaiwa Corporation will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. All parts and accessories replaced under this warranty become the property of Shindaiwa Corporation

To locate an authorized Shindaiwa dealer near you, contact your Shindaiwa Distributor. For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-

3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

LIMITATIONS

The Federal Emission Design and Defect Warranty shall not cover any of the following:

THIS WARRANTY IS ADMINISTERED BY

Shindaiwa Inc.

11975 S.W. Herman Rd. Tualatin OR. 97062 (503) 692-3070

Shindaiwa Inc.

Shindaiwa Corporation

© 2007 Shindaiwa Inc.

11975 SW Herman Rd.

6-2-11, Ozuka-Nishi,

Part Number 81372

Tualatin, Oregon 97062 U.S.A.

Asaminami-Ku, Hiroshima

Revision 3/07

Telephone: 503 692-3070

731-3167, Japan

Shindaiwa is a registered trademark of Shindaiwa, Inc.

Fax:

503 692-6696

Telephone: 81-82-849-2220

Specifications subject to change without notice.

www.shindaiwa.com

Fax:

81-82-849-2481

 

Image 16
Contents T222 Trimmer F222 Trimmer Contents IntroductionSafety Instructions Properly Equipped OperatorWork Safely Stay Alert Minimize the Risk of FireBe Aware of the Working Environment FeetPrior to Assembly SpecificationsProduct Description Adjust Throttle Lever Free Play Assembly and AdjustmentsHandle Assembly Install the Cutting Attachment Shield T222Install the Cutting Attachment Shield F222 Cutting Attachment ShieldMixing Fuel Filling the Fuel TankStarting the Engine Be used in your Shindaiwa engineWhen the Engine Starts Idle Speed AdjustmentStopping the Engine Never start the engine from the operating positionChecking Unit Condition Cutting GrassEngine Operating Speeds Trimming and Mowing GrassDaily Maintenance General MaintenanceHour Maintenance Gearcase Lubrication T222 Only 10/15-Hour MaintenanceRemove and replace the filter element Long Term Storage Every 100 hours of operation, removeTroubleshooting Guide Engine does not StartAdditional Problems Manufacturers Warranty Coverage OWNER’S Warranty ResponsibilitiesMaintenance and Repair Requirements Obtaining Warranty ServicePodadora T222 Podadora F222 ¡ADVERTENCIA¡PRECAUCiÓN Introducción Declaraciones de SeguridadNota Instrucciones de Seguridad El Operario Debidamente EquipadoEtiquetas de Seguridad Esté Alerta En Su Área De TrabajoPies Especificaciones Descripción del ProductoAntes de Ensamblar Ensamblaje y Ajustes Ajuste la holgura del aceleradorEnsamblaje ¡PRECAUCIÓNMezcla de Combustible Llenando el Tanque de CombustibleArranque del Motor Ejemplos de cantidades de mezcla a proporción deArranque del Motor continuación Parada del MotorAjuste de Marcha Mínima del Motor Cuando arranca el motor…Verifique la Condición de la Unidad Corte de Césped Máquinas Equipadas con Cabezal de CorteVelocidades de operación del motor Cortar y recortar el céspedMantenimiento Diario Mantenimiento GeneralMantenimiento Cada 10 Horas Mantenimiento Cada 50 Horas Mantenimiento Cada 10/15 HorasRetire y reemplace el elemento del filtro Cada 100 horas Mantenimiento Almacenamiento de Largo PlazoGuia Diagnostico El Motor No ArrancaGuia Diagnostico continuación Problemas AdicionalesEsta Garantía ES Administrada POR Cobertura DE LA Garantía DEL FabricantePiezas Cubiertas LimitacionesDébroussailleuses T222 F222 AvertissementIntroduction Mises en garde Table des matièresAvertissement ! Les gaz d’échappement du Mise EN GardeMesures de sécurité Équipement complet de l’utilisateurSécurité au travail Demeurer alerteTenir compte de l’environnement de travail Étiquettes de sécuritéCaractéristiques techniques NomenclatureAvant l’assemblage Réglage du jeu du levier d’accélération Assemblage et réglagePoignée Installation du déflecteur T222 Installation du déflecteur F222Tête de coupe Installer la tête de coupe AssemblageMélange de carburant Remplissage du réservoir à carburantDémarrage du moteur Réduire les risques d’incendieDémarrage du moteur suite Arrêt du moteurRéglage du ralenti du moteur Lorsque le moteur démarreContrôle de l’état de l’appareil Vitesses de fonctionnement du moteurTailler et tondre la pelouse Faire les borduresEntretien quotidien EntretienEntretien aux 10 heures Retrait et remplacement de l’élément du filtre Entretien aux 10 à 15 heuresToutes les 10 à 15 heures de fonctionnement Lubrification du boîtier réducteur T222 seulementEntretien aux 100 heures Remisage à long termeGuide de dépannage Des segmentsGuide de dépannage suite Autres ProblèmesÉtendue DE LA Garantie DU Fabricant Pièces Prises EN ChargeExigences Relatives À L’ENTRETIEN ET LA Réparation LA Présente Garantie EST Gérée PARRemarques FR18 FR19

81372, T222, F222 specifications

The Shindaiwa F222, 81372, and T222 are notable models within Shindaiwa's robust lineup of landscaping equipment, particularly designed for professional use. These tools are engineered to deliver high performance and reliability, making them ideal for both commercial landscapers and dedicated homeowners.

The Shindaiwa F222 is a powerful handheld blower known for its superior air speed and volume. With an exceptional engine output, it efficiently clears debris from various surfaces including lawns, gardens, and walkways. Its lightweight design ensures ease of use, reducing fatigue during extended operation. The F222 features an ergonomic handle that allows for a comfortable grip, and its well-balanced construction guarantees stability when in use. Additionally, the blower incorporates a low-emission engine technology, adhering to stringent environmental standards while still delivering ample power.

The Shindaiwa 81372 is recognized for its versatility as a hedge trimmer. This model boasts a dual-sided blade that provides a clean and precise cut, making it perfect for shaping and maintaining hedges and shrubs. The 81372 is equipped with a smooth-running, low-vibration motor that enhances user comfort, particularly during prolonged use. Furthermore, its lightweight and compact design make maneuvering easy, allowing operators to access tight spaces without hassle. With a focus on durability, Shindaiwa has designed the 81372’s blades to resist wear and maintain sharpness over time, ensuring longevity and optimal performance.

The T222, a robust trimmer, showcases Shindaiwa's commitment to power and efficiency. Engineered with a high-performance engine, the T222 delivers fast and efficient cutting, making it suitable for tackling thick grass and weeds. Its adjustable cutting head adds to its versatility, enabling users to reach various angles with ease. Additionally, the T222 is built with a comfortable grip and user-friendly interface, allowing for extended use without discomfort. Its lightweight construction makes it easy to handle, reducing the strain on the operator.

Across these models, Shindaiwa emphasizes innovative technologies, such as anti-vibration systems and fuel-efficient engines, ensuring that users can rely on their tools for productivity without compromising comfort. Overall, the Shindaiwa F222, 81372, and T222 represent a blend of power, efficiency, and user-friendly features, making them essential tools for landscaping professionals and enthusiasts alike.