Shindaiwa T222, F222, 81372 manual Long Term Storage, Every 100 hours of operation, remove

Page 13

100-hour Maintenance

Every 100 hours of operation, remove

and clean the muffler.

WARNING!

Never operate this trimmer with a damaged or missing muffler or spark arrester! Operating with missing or damaged exhaust components is a fire hazard, and can also damage your hearing!

1. Remove the spark plug boot.

. With a 3 mm hex wrench remove the 1 muffler cover and 3 engine cover screws and the engine cover. See Figure 25.

3.With a Phillips type screwdriver remove the 5 screws holding the spark arrester screen and cover to the muffler. See Figure 25.

4.Remove the screen and clean it with a stiff bristle brush.

5.With a 4 mm hex wrench remove the 3 muffler bolts and the muffler. See Figure 25.

6.Inspect the cylinder exhaust port for any carbon buildup.

7.Gently tap the muffler on a wood sur- face to dislodge any loose carbon.

Engine Cover

Engine

 

 

 

Cover

 

 

 

Screws

 

 

 

 

 

 

 

 

 

Muffler

 

 

 

 

Cover

 

 

 

 

Muffler

 

 

 

Cover Screw

 

 

 

 

Muffler

 

 

 

Muffler

Screws

 

 

 

 

 

 

 

Gasket

Screws

 

 

 

 

 

Muffler

Spark Arrester

Spark Arrester

Outlet

 

Gasket

Screen

Cover

 

Figure 25

 

 

 

 

 

8. Reassemble the spark arrester, muffler

IMPORTANT!

If you note excessive carbon buildup, consult

and engine cover in the reverse order of

disassembly.

with an authorized Shindaiwa servicing dealer.

 

Long Term Storage

Whenever the unit will not be used for 30 days or longer, use the following procedures to prepare it for storage:

■Clean external parts thoroughly.

■Drain all the fuel from the fuel tank.

IMPORTANT!

All stored fuels should be stabilized with a

fuel stabilizer such as STA-BIL™, if

oil

with fuel stabilizer is not used.

CAUTION!

Gasoline stored in the carburetor for extended periods can cause hard starting and could also lead to increased service and maintenance cost.

■Remove the remaining fuel from the fuel lines and carburetor.

1.Prime the primer bulb until no more fuel is passing through.

. Start and run the engine until it stops running.

3.Repeat steps 1 and 2 until the engine will no longer start.

■Remove the spark plug and pour about 1/4 ounce of 2-cycle mixing oil into the cylinder through the spark plug hole.

Slowly pull the recoil starter 2 or 3 times so oil will evenly coat the interior of the engine. Reinstall the spark plug.

■Before storing the unit, repair or replace any worn or damaged parts.

■Remove the air cleaner element from the carburetor and clean it thoroughly with soap and water. Let dry and reassemble the element.

1. Store the unit in a clean, dust-free area.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents T222 Trimmer F222 Trimmer Introduction ContentsProperly Equipped Operator Safety InstructionsWork Safely Stay Alert Minimize the Risk of FireFeet Be Aware of the Working EnvironmentPrior to Assembly SpecificationsProduct Description Adjust Throttle Lever Free Play Assembly and AdjustmentsHandle Install the Cutting Attachment Shield T222 AssemblyInstall the Cutting Attachment Shield F222 Cutting Attachment ShieldFilling the Fuel Tank Mixing FuelStarting the Engine Be used in your Shindaiwa engineIdle Speed Adjustment When the Engine StartsStopping the Engine Never start the engine from the operating positionCutting Grass Checking Unit ConditionEngine Operating Speeds Trimming and Mowing GrassDaily Maintenance General MaintenanceHour Maintenance Gearcase Lubrication T222 Only 10/15-Hour MaintenanceRemove and replace the filter element Every 100 hours of operation, remove Long Term StorageEngine does not Start Troubleshooting GuideAdditional Problems OWNER’S Warranty Responsibilities Manufacturers Warranty CoverageMaintenance and Repair Requirements Obtaining Warranty Service¡ADVERTENCIA Podadora T222 Podadora F222¡PRECAUCiÓN Introducción Declaraciones de SeguridadNota El Operario Debidamente Equipado Instrucciones de SeguridadEtiquetas de Seguridad Esté Alerta En Su Área De TrabajoPies Especificaciones Descripción del ProductoAntes de Ensamblar Ajuste la holgura del acelerador Ensamblaje y Ajustes¡PRECAUCIÓN EnsamblajeLlenando el Tanque de Combustible Mezcla de CombustibleArranque del Motor Ejemplos de cantidades de mezcla a proporción deParada del Motor Arranque del Motor continuaciónAjuste de Marcha Mínima del Motor Cuando arranca el motor…Corte de Césped Máquinas Equipadas con Cabezal de Corte Verifique la Condición de la UnidadVelocidades de operación del motor Cortar y recortar el céspedMantenimiento Diario Mantenimiento GeneralMantenimiento Cada 10 Horas Mantenimiento Cada 50 Horas Mantenimiento Cada 10/15 HorasRetire y reemplace el elemento del filtro Almacenamiento de Largo Plazo Cada 100 horas MantenimientoEl Motor No Arranca Guia DiagnosticoProblemas Adicionales Guia Diagnostico continuaciónCobertura DE LA Garantía DEL Fabricante Esta Garantía ES Administrada PORPiezas Cubiertas LimitacionesAvertissement Débroussailleuses T222 F222Table des matières Introduction Mises en gardeAvertissement ! Les gaz d’échappement du Mise EN GardeÉquipement complet de l’utilisateur Mesures de sécuritéSécurité au travail Demeurer alerteÉtiquettes de sécurité Tenir compte de l’environnement de travailCaractéristiques techniques NomenclatureAvant l’assemblage Réglage du jeu du levier d’accélération Assemblage et réglagePoignée Installation du déflecteur F222 Installation du déflecteur T222Tête de coupe Installer la tête de coupe AssemblageRemplissage du réservoir à carburant Mélange de carburantDémarrage du moteur Réduire les risques d’incendieArrêt du moteur Démarrage du moteur suiteRéglage du ralenti du moteur Lorsque le moteur démarreVitesses de fonctionnement du moteur Contrôle de l’état de l’appareilTailler et tondre la pelouse Faire les borduresEntretien quotidien EntretienEntretien aux 10 heures Entretien aux 10 à 15 heures Retrait et remplacement de l’élément du filtreToutes les 10 à 15 heures de fonctionnement Lubrification du boîtier réducteur T222 seulementRemisage à long terme Entretien aux 100 heuresDes segments Guide de dépannageAutres Problèmes Guide de dépannage suitePièces Prises EN Charge Étendue DE LA Garantie DU FabricantExigences Relatives À L’ENTRETIEN ET LA Réparation LA Présente Garantie EST Gérée PARRemarques FR18 FR19

81372, T222, F222 specifications

The Shindaiwa F222, 81372, and T222 are notable models within Shindaiwa's robust lineup of landscaping equipment, particularly designed for professional use. These tools are engineered to deliver high performance and reliability, making them ideal for both commercial landscapers and dedicated homeowners.

The Shindaiwa F222 is a powerful handheld blower known for its superior air speed and volume. With an exceptional engine output, it efficiently clears debris from various surfaces including lawns, gardens, and walkways. Its lightweight design ensures ease of use, reducing fatigue during extended operation. The F222 features an ergonomic handle that allows for a comfortable grip, and its well-balanced construction guarantees stability when in use. Additionally, the blower incorporates a low-emission engine technology, adhering to stringent environmental standards while still delivering ample power.

The Shindaiwa 81372 is recognized for its versatility as a hedge trimmer. This model boasts a dual-sided blade that provides a clean and precise cut, making it perfect for shaping and maintaining hedges and shrubs. The 81372 is equipped with a smooth-running, low-vibration motor that enhances user comfort, particularly during prolonged use. Furthermore, its lightweight and compact design make maneuvering easy, allowing operators to access tight spaces without hassle. With a focus on durability, Shindaiwa has designed the 81372’s blades to resist wear and maintain sharpness over time, ensuring longevity and optimal performance.

The T222, a robust trimmer, showcases Shindaiwa's commitment to power and efficiency. Engineered with a high-performance engine, the T222 delivers fast and efficient cutting, making it suitable for tackling thick grass and weeds. Its adjustable cutting head adds to its versatility, enabling users to reach various angles with ease. Additionally, the T222 is built with a comfortable grip and user-friendly interface, allowing for extended use without discomfort. Its lightweight construction makes it easy to handle, reducing the strain on the operator.

Across these models, Shindaiwa emphasizes innovative technologies, such as anti-vibration systems and fuel-efficient engines, ensuring that users can rely on their tools for productivity without compromising comfort. Overall, the Shindaiwa F222, 81372, and T222 represent a blend of power, efficiency, and user-friendly features, making them essential tools for landscaping professionals and enthusiasts alike.
Top Page Image Contents