5.2.6.2 Panel Light / Pilot Lamp
Pilot Lamp indicates whether or not generator is generating electricity,
when the engine is driving.
5.2.7Switch
5.2.7.1Starter Switch
STOP
①When the switch is set to this position, all power will be off. The switch must be set to this position to remove the key.
RUN
②The switch must be set to this position during operation.
<Caution>
START
③This position will allow user to start the engine. When a user release the key, the setting will automatically return to <RUN> position.
PREHEAT
④This position will allow generator to preheat the glow plug during startup in cold environment
5.2.7.2 Emergency Stop button
This button is used to stop the engine in emergency. Keep pressing the button until the engine comes to complete halt.
<Caution>
Keep pressing the button until the engine stops in several seconds. After the engine stops, be sure to return the starter switch to the
STOP Position.
By turning< this> circuit breaker switch to ON position, power will be transferred to the output terminal and to the load side. By turning to OFF position, it will shut down all power to the load side, preventing overload and
<Caution>
Do not use this breaker as the ON/OFF switch to the load.
- 14 -