Shindaiwa DG1000MI manual Operation Check Electrical Shock

<Caution>

￿In the event you cannot ground the generator to the earth, consult with the authorized distributor or our engineering section

7.3.2 Operation Check

Danger

:Electrical Shock

EARTH

GROUNDINGBONNET

TERMINALGROUNDING TERMINAL

GROUNDING ROD

￿Before turning the 3-Phase circuit breaker to ON position, ensure that the breaker or the Switch of loads are positioned to OFF. Operate the 3-Phase circuit breaker, well-communicating with the electrician by the load side.

Before operating the generator, check always if the device can work.

①	Ensure that the breakers and the switches of load(s) are 3-PHASE CIRCUIT BREAKER
	positioned to OFF.
	Ensure that the 3-Phase circuit breaker and the 1-Phase		1-PHASE CIRCUIT BREAKER
	circuit breaker are positioned to OFF.
	Following the procedure in 9-1, Initializing/Preparation, start
	an engine.
	Turn (Push-up) the 3-Phase circuit breaker (lever) and the
	1-Phase circuit breaker (lever) to ON position.
	Push the test button (red) in the earth leakage relay unit.
②	When the button is pushed, the earth leakage indicating			EARTH LEAKAGE RELAY
	lamp turns ON and circuit breakers are positioned in the
③	middle between ON and OFF positions simultaneously, the
	device works normally.		EARTH LEAKAGE RELAY
⑥	Push the reset button. The earth leakage indicating lamp (red)	INDICATING LAMP
	turns OFF subsequently.
④
⑦	Turn (Push-down) the 3-Phase circuit breaker (lever) and the
	1-Phase circuit breaker (lever) to OFF position.
⑤

In the event you cannot complete every step of the above procedure

TEST BUTTON

to the end, the device is out of order. Consult with our authorized

RESET BUTTON

distributor or our engineering section and ask to repair.

- 24 -