Shindaiwa DG1000MI manual Checking Fuel, Engine Oil, and Water leakage, Checking Battery

Page 30

Notice: Do not use home heating oil or gasoline in your diesel engine; either may cause engine damage.

8.5 Checking Fuel, Engine Oil, and Water leakage

Caution

:Fire

￿Do not use this equipment when a leak is found. Repair the equipment before use.

Be sure to check for any fuel leak at the hose connection, and oil and coolant leak by opening side doors.

8.6 Checking Battery

Caution

:Injuries to eyes and skin

￿Battery fluid contains diluted sulfuric acid. Avoid contact with eyes, skin or on clothing.

If the acid comes in contact, especially with eyes, flush with a lot of water, and contact your physician immediately.

Caution

:Fire

￿Do not use the equipment or charge the battery, in the case the battery fluid level is lower than the LOWER level.

￿Battery may emit some combustible gas, so keep it away from fire and sparks.

Check the fluid level. If the level is near or lower than the MIN level, add distilled water until the fluid level reaches the MAX limit.

Make sure that the battery cables are firmly secured

 

to the posts. Tighten the clamps if necessary.

<Caution>

￿ Check the hydrometer of the battery fluid.

If it falls below 1.23, the battery requires

recharging.Please call our authorized

distributor or our engineering section.

 

- 30 -

Image 30
Contents DG1000MI Introduction Electrical Shock Safety GuidelinesSuffocation from exhaust fume InjuriesFire Injuries to eyes and skinExplosion BurnsInjuries Location of Warning labels Specifications Specification MatrixUse Parts Ambient ConditionExternal view Control panel Equipment Monitor DisplayEngine Oil Monitoring Lamp for oil pressure low Injuries Gauges Battery Charge Monitoring Lamp charge lampWater Temperature Gauge Hour Meter built into the TachometerAmp Meter Fuel GaugeGenerator Gauges Frequency MeterSwitch Starter Switch Panel Light / Pilot LampEmergency Stop button Earth Leakage Relay Unit Amp Meter Changeover SwitchThermal Relay Voltage Regulator and Throttle LeverUsing fuel from built-in fuel tank Fuel Line Changeover Valve 3-way valve< > Lifting Equipment Transport and InstallationTransportation TransportationInstallation ConnectionSelecting Cable Electrical damages Connecting Cable Load Connection Terminal Plate 3-Phase For 3-Phase LoadFor 1-Phase Load1 For 1-Phase Load2 2 1-Phase Output Terminals & ReceptaclesEarth Leakage Relay and Grounding Grounding WorkOperation Check Electrical Shock Electrical Shock Injuries Initialization and pre-checkEarth leakage breaker relay has activated Fire BurnsChecking Engine Oil Selecting proper engine oilEngine Oil Capacity Checking Coolant/water Checking Radiator / Adding water Checking Coolant reservoir tank / Adding coolant Checking Fan Belt Coolant CapacityTension Checking Fuel ConditionChecking Battery Checking Fuel, Engine Oil, and Water leakageReplacing the battery Operation Initializing / preparationFrequency Adjust Screw 200/400 Voltage Changeover Dual Voltage System Damages to the propertyRefer to 7-2. Connecting cable During operationProtection Features Feature ListStopping the Generator Connecting to External Fuel Tank During Operation sectionMaintenance Engine Side Generator side10.1 Oil Change Replace, refer to 8-1 Checking Engine OilCleaning / Changing Air Filter Element Cleaning / Changing Fuel Filter Draining Water from Water SeparatorClean gauze filter in water separator Clean gauze filter in engine feed pumpIsuzu Part No 8970631550 Draining Water from Fuel Tank Storage Procedures Long-term StorageStacking Troubleshooting Ask our distributor to repair Page Generator Wiring Diagram Engine Wiring Diagram